EQ 300mg/ml with low BB?

Discussion in 'Steroid Homebrew' started by DeVille Papo, Dec 4, 2018.

  1. DeVille Papo

    DeVille Papo Member

    Going to use 1% BA. Would 5% BB be fine for 300mg/ml? BB even necessary for it? I know you don't have to use BB for Test E @ 250mg/ml
  2. master.on

    master.on Member

    It should hold fine no BB.
  3. DeVille Papo

    DeVille Papo Member

    Thanks for the reply bud. Yes was hoping someone would say that lol. Just don't wanna make some and have it crash or anything and have to re-do it. If I do use some, it'll be 5%
  4. JackSmooth

    JackSmooth Member

    Would be a good idea to use some just to thin it out.
  5. Iron Frenchie

    Iron Frenchie Member

    No BB necessary. EQ is IMO is the smoothest injectable out there even at 300ml/mg.
    eje1990 likes this.
  6. Johne71

    Johne71 Member

    I’ve seen it produced at 400mg/ml. BB was only added to thin it so it would push easier. Thick oil sucks to pin.
  7. DeVille Papo

    DeVille Papo Member

    I ended up using 10% BB just to thin it out. I'll do 5% next time though