Bad gear

[T_verde77]

Really bad pip from home brew test e.

10 shots in the the pip is still so bad where it hurts to walk.

I've tried filtering it and diluting it.

What else could it possibly be.

Not exactly sure on the actual recipe because I didn't save it :/. But I've homebrewed a lot before. I may of made a mistake somewhere.
I've always just used 2% ba, 20% bb, and GSO for the oil

Is there anything I can do to salvage all this gear or would u guys just scrap it all. I would hate to throw all this away but I'm not sure what else to do.

Thanks in advance for the help

 

[Kristo32]

I have EXACTLY the same problem. Test e @250. I did 100g raw, ba 4ml (I think I can't quite recall), bb 40ml (same) and topped up to 400ml cottonseed oil.
Heated and dissolved before putting through 500ml pvdf pump filter.
Everything was rinsed in Iso alcohol before being baked to sterilise (vials, Pyrex etc) once bottled all seemed fine but 1ml injected leaves me literally unable to walk for 2 days with no redness etc but swelling.

Going to ditch the lot and go again.

No issue with raw powder but it is possible I suppose that in my haste I swapped the ba and bb figures. I didn't think I did but I guess that would do it due to high levels of ba.

Perhaps you did the same?

 

[T_verde77]

That's the only possibility I could think of. Possibly got too careless and measured the bb wrong. Idk what else it could of been.
Because it is just hard to walk still after a shot and the pain does go away after a couple of days. Lesson learned. No point in doing the gear if it's hard to walk and can't even hit leg day. It's not the raw because I had a good batch out of the same stuff earlier

400ml wasted :/

Also if u totally swapped the figures I think would leave a little more messed up than that idk

 

[Kristo32]

That's the only possibility I could think of. Possibly got too careless and measured the bb wrong. Idk what else it could of been.
Because it is just hard to walk still after a shot and the pain does go away after a couple of days. Lesson learned. No point in doing the gear if it's hard to walk and can't even hit leg day. It's not the raw because I had a good batch out of the same stuff earlier

400ml wasted :/

Also if u totally swapped the figures I think would leave a little more messed up than that idk

I'm more concerned now as I've just checked my levels of bb and ba as they were new bottles and I def did not screw up the levels??????

I've no idea why this has happened!

 

[bonacris]

Not too long ago a lot of labs had really pippy test e because they all got a crappy batch of raws that had carbolic acid that wasn't washed off so it was really stingy. like brutal. it could be that you got some of these raws

 

[ickyrica]

Did you get it during a September special a source in Meso had? Thx

 

[T_verde77]

No it was not a source on here. Like I said it is not the powder because I had a good batch from the exact same powder

 

[Kristo32]

I wrote about my issue in the forum as discussed here:

Something went wrong test e brew

Don't know if the added bb works as yet but might be worth bearing in mind. I'll let you know how it goes

 

[T_verde77]

Let

I wrote about my issue in the forum as discussed here:

Something went wrong test e brew

Don't know if the added bb works as yet but might be worth bearing in mind. I'll let you know how it goes

let me know how it goes