Brewing Injectable Tbol/Proviron

Hi all,

I’m ordering Sustanon, Tbol, and Proviron raws for my upcoming cutting cycle. I plan on using the proviron at the beginning to crush shbg and then maybe towards the end for some extra hardness. I’m using the tbol like anavar, just to get better pumps and whatnot. However, I’m not too keen on making capsules and dealing with the equipment needed for that. Does anyone have experience brewing Tbol or Proviron in either oil or suspension?
 
Yea bro just grab some Humco suspension vehicle and dose 1g raw with Tbol and 49ml Hum for 50ml @ 20mg/ml. For the Prov do 3g raw with 57 Hum for 60ml @ 50mg/ml. I had to grind the raws in a Mortar and Pestle to get them to suspend properly for both compounds as the are a grainy sugary like substance. Super easy.
 
Yea bro just grab some Humco suspension vehicle and dose 1g raw with Tbol and 49ml Hum for 50ml @ 20mg/ml. For the Prov do 3g raw with 57 Hum for 60ml @ 50mg/ml. I had to grind the raws in a Mortar and Pestle to get them to suspend properly for both compounds as the are a grainy sugary like substance. Super easy.
Bro thank you for this, really saved me the trouble of buying a capping machine. Would you use any type of filter? I'm assuming no because its a suspension, not a solution.
 
Correct it’s going systematically via oral route. No need to filter. Only thing I would do for long term storage is replace 5-10 ml of the suspension with 190 proof Everclear to keep micro bacteria from growing.

Example: 50ml Tbol 20mg/ml

1g 4-Chlorodehydromethyltestosterone
5ml Everclear
44ml Humco.
Mix components and shake well before each use.
 
So the title of brewing injectable Tbol really meant how to make an oral suspension right?

As far as capping goes it's not expensive or hard it's just a little time consuming.
 
So the title of brewing injectable Tbol really meant how to make an oral suspension right?

As far as capping goes it's not expensive or hard it's just a little time consuming.
As i’ve looked into it, the oral route sounds best. I was initially wondering if it’s possible to make any oral into an injectable, but i’ve really only seen that done with Anadrol and Dbol.

And as far as capping, you’re right. I’ve seen machines for under $20 that’ll get the job done. I’m fine going the liquid route though.
 
Correct it’s going systematically via oral route. No need to filter. Only thing I would do for long term storage is replace 5-10 ml of the suspension with 190 proof Everclear to keep micro bacteria from growing.

Example: 50ml Tbol 20mg/ml

1g 4-Chlorodehydromethyltestosterone
5ml Everclear
44ml Humco.
Mix components and shake well before each use.
Been trying to find this for a few days lol
 
Back
Top