Cutting with grapeseed oil

[Hex]

I had a couple of questions I hope y'all can help me with. I ordered some 500 mg/ml Test Enanthate. PIP has been excruciating (it happened last cycle as well with 300 mg/ml. I had blood done so I "know" the stuff is legit). After doing some reading up here the consensus seems to be to cut it with grapeseed oil. So, I got the grapeseed from Med Lab Supply. Description says it's USP, been filtered w/ .22 filter, etc. Is it good to go as is or do I need to do another step? Also, I read a lot about heating it up, injecting slowly, massaging the site -all of which I forgot to do when I started so I'll do that as well. I was going to cut each ml with 1.5 ml oil. My understanding is that I'll draw from the test, then draw from the oil, change needles, then inject - is that correct? Thx.

 

[Se1ch3r]

.

 

[Sk8man101]

I had a couple of questions I hope y'all can help me with. I ordered some 500 mg/ml Test Enanthate. PIP has been excruciating (it happened last cycle as well with 300 mg/ml. I had blood done so I "know" the stuff is legit). After doing some reading up here the consensus seems to be to cut it with grapeseed oil. So, I got the grapeseed from Med Lab Supply. Description says it's USP, been filtered w/ .22 filter, etc. Is it good to go as is or do I need to do another step? Also, I read a lot about heating it up, injecting slowly, massaging the site -all of which I forgot to do when I started so I'll do that as well. I was going to cut each ml with 1.5 ml oil. My understanding is that I'll draw from the test, then draw from the oil, change needles, then inject - is that correct? Thx.

If you cut each ml with 1.5 ml of oil your not gunna get 300mg/ml.
I've never brewed before but ideally yes it is sterial cause it's been filtered, but if it was me, just for peice of mind I'd probably filter it again.

 

[Riz]

For educational purposes, why would someone need Test E that's dosed that high?

 

[Hex]

I wanted to get it down to 200, which is what it'll do. Even the 300 was tough last time.

 

[Hex]

For educational purposes, why would someone need Test E that's dosed that high?

It was cheaper per ml to buy it that way. Probably won't do that again.

 

[Riz]

I see. Instead of cutting it down with grape seed oil couldn't you just pin half a cc at a time instead of a full cc?

 

[Hex]

Well, I could, but then I'd be pinning 2x as much. I had read that sometimes a high concentration can increase PIP, I figured it would still hurt at the lower volume because the concentration is still the same.

 

[doctor jones]

Take a Half of cc and take it like a champ if not cut it wit this oil. Works great

 

[daylight driller]

It was cheaper per ml to buy it that way. Probably won't do that again.

Is it really cheaper once you buy gso and sterile cials to cut it?

 

[Hex]

No, but I was ignorant about cutting it at the time - I only researched it after the first injection and the subsequent pain. I didn't think it would hurt as much and it's been a while since my last cycle so I kinda forgot how much those first few hurt. Like I said, I won't be doing that again.

 

[SuperMaroid]

I have had gear that gave me terrible pip and had great results cutting it with GSO. If your trying to pin 1cc, add a quarter cc GSO, then a quarter cc of test, keep doing that until you reach 2cc. Then switch needles and inject.I noticed almost no pip if I kept adding a quarter cc of each rather then just adding one then the other.

If the gear is giving you really bad pip it wont matter if you inject 1cc or half a cc you will still feel the pip. GSO is the best option to stop the pip.

If it says its sterile filtered GSO then your g2g.

 

[MedLabGear]

I had a couple of questions I hope y'all can help me with. I ordered some 500 mg/ml Test Enanthate. PIP has been excruciating (it happened last cycle as well with 300 mg/ml. I had blood done so I "know" the stuff is legit). After doing some reading up here the consensus seems to be to cut it with grapeseed oil. So, I got the grapeseed from Med Lab Supply. Description says it's USP, been filtered w/ .22 filter, etc. Is it good to go as is or do I need to do another step? Also, I read a lot about heating it up, injecting slowly, massaging the site -all of which I forgot to do when I started so I'll do that as well. I was going to cut each ml with 1.5 ml oil. My understanding is that I'll draw from the test, then draw from the oil, change needles, then inject - is that correct? Thx.

ill reiterate it is in fact - sterile & filtered with a 0.22um PVDF 45mm micron filter. Thanks for your business and hope this rectifies your problem!

 

[DrinkFlintWater]

why does GSO skyrocket my BP for 2 days after injection? Only carrier that seems to do this to me

 

[Jtsmith256]

Old thread here but maybe i'll get some luck. I have 500 test e so its thick as hell and little did i know i was about to go through terrible pain. I bought grapeseed oil but its NOT sterile. Will boiling it sterilize it or do i have to filter it? Dont really feel like buying the filter for a one time mistake if i can just boil it

 

[Big_paul]

I had a couple of questions I hope y'all can help me with. I ordered some 500 mg/ml Test Enanthate. PIP has been excruciating (it happened last cycle as well with 300 mg/ml. I had blood done so I "know" the stuff is legit). After doing some reading up here the consensus seems to be to cut it with grapeseed oil. So, I got the grapeseed from Med Lab Supply. Description says it's USP, been filtered w/ .22 filter, etc. Is it good to go as is or do I need to do another step? Also, I read a lot about heating it up, injecting slowly, massaging the site -all of which I forgot to do when I started so I'll do that as well. I was going to cut each ml with 1.5 ml oil. My understanding is that I'll draw from the test, then draw from the oil, change needles, then inject - is that correct? Thx.

I have had similar experiences in the past. First of all don't buy 500mg/cc gear.

Cut it but the dose may not be the only problem. It could be BA is too high, or most likely EO was used.

 

[twiztid1]

Old thread here but maybe i'll get some luck. I have 500 test e so its thick as hell and little did i know i was about to go through terrible pain. I bought grapeseed oil but its NOT sterile. Will boiling it sterilize it or do i have to filter it? Dont really feel like buying the filter for a one time mistake if i can just boil it

It's $6 and 5 min for piece of mind.

 

[daylight driller]

Old thread here but maybe i'll get some luck. I have 500 test e so its thick as hell and little did i know i was about to go through terrible pain. I bought grapeseed oil but its NOT sterile. Will boiling it sterilize it or do i have to filter it? Dont really feel like buying the filter for a one time mistake if i can just boil it

No do not boil your oil in order to sterilize it. You can buy sterile vials on ebay cheap then get some gso from the grocery store make sure it is cold pressed. Look at the ingredients the only ingredient should be gso. Get at least 2 .22 syringe filters and a cauljing gun. Its easy and in the end you will have a sterile product.