bdg77
New Member
This is something that always seemed a little off to me. When using pre-sterilized/sealed vials, would the pressure inside the cooker not force steam (water) into the vials through the punctures created by the needles used to fill them? I know they basically seal off when the needle is removed, but there's still going to essentially be a hole/weak spot there for the pressure to equalize, no?
Or are vial stoppers really that good at self sealing? This study does seem to indicate they are pretty amazing, unrelated to pressure differentials though.
http://www.ncbi.nlm.nih.gov/pubmed/23636157
The purpose of the pressure cooker is to compensate for the build up of pressure in vial. So what your trying to achieve is equal pressure outside and inside the vial. Too much in vial and the seal may fail and top could explode. Too much outside pressure and there could be the possibility of steam getting in. You basically want the vial to reach a certain internal temp and then let it cool. Excessive heat isn't good and could make compound break down quicker. If it were for personal a .45 filter and oven bake with a small pin to bleed pressure would be good enough for me. However in a situation where it needs to be capped and a pin hole would not be acceptable, that's where I think a pressure cooker could come in clutch. I'm sure there's a bit more to the process this than the simple explanations I've read. For example would you want to heat up slowly or put in once water is already almost boiling. I was thinking putting in a control vial of just veg. oil would be a good idea. That way you could open it and test internal temp.
