Filtering steroid issue

[Big_paul]

Hi guys, so today i was for the first time making my steroid. I did tren ace 5g + 1ml BA + 10ml BB + 34ml grapeseed oil for 50ml tot 100mg/ml.
Problem is that when i had to filter with the 0.22 it was so fucking slow! my hand hurt so much... it took me like 1 hour to do 9-10ml !!
I had to change the filter every 3ml cus it got so hard ( like 1 drop every 20-30 sec...) .
What can be the problem? why is so hard to filter? could be cus i used 5ml syringe and maybe need a 50ml?

If im brewing personal I only filter 20 ml at a time. For commercial you would need to use another method.

Syringe filters suck but if you only need to filter every 2-3 weeks they work.

Good luck with the 50. You think what you are using now is fucked, using a 50ml will write a new chapter in fucked up.

 

[oxezo]

Shit, sorry I assumed you were using implants. How long did you let disolve before filtering? Was it cloudy still when filtering? If so maybe heat it just a little to get it fully disolved. Not too much. Just bring some water to a boil and put in a bowl. Wait a minute before placing beaker in water and let sit until water is luke warm. Swirl. Only thing I can think is it was not fully disolved. .22 filter should be fine.

First 10ml i filtered i waited like 5-10min. But i have 40ml left to disolve at least 6-7 days before i got new syringe to filter them

 

[Johne71]

This should give you an idea. Not my image but found it online.

@Samael