homebrew irritation. help.

[Anabolicbrah]

So I need help here I'm starting to get a lil worried. I followed all the sterile procedures. I got my raws from a source I've used before. This time I brewed up test e @ 250mg/ml and I brewed about 200ml worth. I used this exact recipe on basskiller

Results - Amounts Needed Oil -
112.85- ml's Powder -50.00 grams ba - 4.00 ml's bb - 36.00 ml's

Ba concentration is 2% BB is 18%

Before I brewed up some test p so I never experienced this problem, but it seems everytime after I pin about 1.5ml of test e. I start getting this red lump on my glutes and it goes away within 2-3 days. I don't get flu like symptoms, I just get a hard lump and redness. This has been happening pretty much everytime I pin. I never got this with pharma test e. I'm not sure what is causing this. I'm wondering if I used too much BA if so. Do I just need to dispose this batch of vials I made and use less? Really need some advice here. Thank you R/steroids

Also, Test is present in this batch of raws. I feel great. I just keep getting a red lump and irritation, I've been blasting and cruising for about a year now. Never had this problem before. I've home brewed with success before. Lump feels a lil warm, a lil painful and hard.

 

[Anabolicbrah]

This is the exact input on basskiller btw
Dosage in mg 250 250mg/ml = 250 Powder Weight
0.943 BA concentration
0.02 2% = 0.02 BB concentration
0.18 18% = 0.18

Results - Amounts Needed Oil -
112.85 - ml's Powder -
50.00 - grams ba -
4.00 - ml's bb -
36.00 - ml's

 

[jacked44]

You need to filter your finished product with a .20 micron filter. The redness is infection.

 

[micro2000]

It's more than likely the test enanthate raws. I had the same problem with some old test e raws. Happened with every shot even if I cut the concentration.

Not sure if it's shitty Chinese processing or decomposition of the raws, but something is causing serious irritation. I went to cyp because of this and been no issues.

Sent from my SM-N920P using Tapatalk

 

[Gear2GoGal]

Sounds like infection.

Sterile bottles
Sterile rubber stoppers
Steril caps

Hands and gloves sterile

Then make sure you filter properly and this should be time consuming. Then bottle after everything is sterile.

Cleanliness is key

 

[Big_paul]

The ba isn't the problem. You are using more bb than you need, but that should not not cause pip either.

It's more than likely the test enanthate raws.

I have seen that before.
Your brewing process is way harder than it needs to be.

 

[XKawN]

Do we know what kind of oil was used? so, it's not the recipe. it's either a link in the chain is not right or you messed up the brew. bad oil, contaminated bb or ba or your raws aren't clean. if you have more raws I would try again with new oil and maybe some new bb. or maybe you can brew a little at a time and switch one element at a time until you figure it out.