Homebrewing Revalor-200 Troubles

[equalme]

So I just heated the beaker of goop to 350F and it fully dissolved. NaOH melting point is 600F and estradiol is 350F. I didn't see how far into the heating it actually started dissolving though. I guess the next batch I'm going to try melting the dried powder to see what I get from it.

 

[nophat]

When you filters the tren what part did you keep?
If you kept the goop you and not the liquid that went threw the filter then you lost your tren.
The liquid should have had distiled water dripped into it.
The crystals will for in the clear liquid then rince that powder that's you tren not the goop.

 

[equalme]

Sorry I don't quite follow what you said.

After the cold distiller water drip, I filtered it and kept what was filtered which should've been tren crystals. The liquid would have been washed away e2 and lye. I then rinsed it with over a gallon of distiller water until it started filtering clear.

 

[nophat]

Their should be no goop.
I have never seen it look this way. It looks like their are still binders in it.
When you filtered it after desolve the binders should have been in the coffee filter correct.

 

[equalme]

I crushed up the pellets, saturated it with HEET plus a bit more so the liquid level is about 1cm above. Let it sit for almost 3 hours, then filtered it through coffee filter. There were stuff that filtered and should be the binders, and the liquid that passed through was yellow and clear. Is it possible for the binders to have dissolved with the tren and estro thus passing through the filter?

 

[micro2000]

Is it possible for the binders to have dissolved with the tren and estro thus passing through the filter?

Yes. The pellets are designed to dissolve over time, so its a good assumption most of it is water soluble.

 

[equalme]

How is it that the binders are crystalizing with the tren then?

 

[micro2000]

Possibly they are less soluble in water than in methanol.

I always thought the first step should be a cold water soak to remove anything water soluble. Then dissolve your hormone, plus remaining less water soluble inerts, in alcohol. Try to remove as much of the inert ingredients first. Of course this adds more time to the process.

 

[A-a-Ron]

So my first time trying out converting revalor-200 to tren ace and I'm running into a bit of trouble.

1.) I used heet to dissolve the crushed pellets (3 hours), then filtered through coffee filter.
2.) I poured in dissolved naoh (30mg since I was told 75mg per five cartridges and I only used two) and let it sit for 1 hour exactly.
3.) Ice cold distilled water and dripped for roughly 30 minutes (~400ml).
4.) Filtered through coffee filter and rinsed with a gallon and half of distilled water.
5.) Air dried for two days and used a card to chop up the powder.
6.) I weighed the dried powder and came out to almost exactly 3.5 gram (I used two cartridges which is a total of 4 grams).
7.) I mixed 1ml BA, 1ml EO, and 30ml GSO to get roughly 100mg/ml.
8.) Problem...the powder is not fully dissolving into the oil. I'm heating it (~225F for 30 minutes) and it still isn't dissolving.

Frustrating that I can't figure out what I did wrong...Any tips? Much appreciated!

You should go to your local livestock auction...just found something very interesting that will save you a lot of steps!

 

[nophat]

Explain.
I would like to know what you found.

 

[Notits]

You should go to your local livestock auction...just found something very interesting that will save you a lot of steps!

I'm going to one in two weeks... Fill us in.