Making your own eq...ba%?..bb%??

[TigerStyle1]

Just ordered some enan and eq powders and would like to hear what percentages of solvents you use for each if you were going for 300mg/ml. I'll be using BA, BB and Soy oil.

I'm thinking 15% BB 2% BA for the EQ - 20%BB and 3%BA for the Enan

I know that Upjohn cypionate contains 20% BB and less then 1% BA in cottonseed oil.

 

[Fronkthis]

I made painless EQ with only 2ml of BA for 10g of EQ.
No BB at all.

as far as test E goes, the formula you got looks good

 

[cinnabar8521]

Test Enanthate 10 gram conversion

Needed
10 grams test E
Benzyl Alcahol 2ml 5% BA
30.5 ml sesame oil
Syringes 3cc & 5/10cc
18 or 20 guage needles
Vial
Sterile Vial
Whatman sterile filter


1. Weigh out 10 grams of powder.
2. Place powder in vial.
3. Add BA to the vial.
4. Heat oil in the oven to help sterilize it, heat to at least 212 degrees F. I usually heat my oil at 275 to be sure, I put the oil in a muffin pan, just fill one of the indentions this is plenty for these experiments. Also heat more oil than you need, as you will not be able to get it all out of the pan.
5. Add oil to the vial, save 2 ml of oil in the syringe for later. Gently shake vial.
6. Heat mixture if necessary. I like heating my powder products, by placing the vial in a frying pan, and placing it on the eye of the stove.
7. Place a 18 or 20 gauge needle in the sterile vial attach whatman sterile filter.
8. Place another needle in the sterile vial to relieve the pressure.
9. Draw out solution with a syringe, run though whatman filter.
10. Take other syringe with 2ml oil, run through whatman into solution.


Makes 40ml @ 250mg/ml

And I use 3 ml's ba in my EQ, it's only in their to kill bugs