Opinions/help on my next cycle.

[KenVar]

so I've come to the decision that I'm gonna run Tren, this will be my forth cycle and would like to experience Tren first hand instead of reading and hearing stories about it, so it's time to make I own judgment.

My source atm has a TTM blend and apparently it's shit hot "it's my best seller" he says.

Test E 150mg
Tren E 150mg
Masteron E 100mg

So will be pinning 2ml PW
300 Test, Tren and 200 Masterson
Anadrol 50mg ED week 1-4

Thinking of running the TTM week 1-12 then finishing up on a Test E week 12-14

My friend has run this same cycle with good results minus the Drol, he finished on Var week 8-12.

Would you make any adjustments or chafe the cycle completely?

Thanks

 

[Boston1977]

what are you looking to get off this cycle and what have you run in the past?

 

[KenVar]

what are you looking to get off this cycle and what have you run in the past?

Previous cycles
Tri Test 400 (800mg PW - 12W)
Test E/Dbol (600mg PW/30mg ED 12W/Dbol 1-4W)
Test E/Deca/Dbol (14W Test E/Deca 12W/Dbol 1-4W)

Always focused on "getting swole"

But from this cycle if like to lose some BF, gain LMM and strength and harden my physique.

 

[Test_Subject]

Thinking of running the TTM week 1-12 then finishing up on a Test E week 12-14

Not much point using test e for such a short time. Get some prop or ace and things will go much smoother. You'll only have to wait a week until PCT instead of three.

 

[Boston1977]

Not much point using test e for such a short time. Get some prop or ace and things will go much smoother. You'll only have to wait a week until PCT instead of three.

Def a good idea to start with Tren A, If the sides fuck you up it will only be in your system for a few days as opposed to tren E where youll be stuck with the sides for weeks.

 

[KenVar]

Would you say the dosage of the TTM blend is ok, or should I up it a little.

Also, would it be a good idea to finish on Var week 8-12 ?

 

[Flaming Dragon]

Anytime I hear from a UGL saying "it's my best seller" I tend to run toward the hills! If you're going to run different compound-why go with a blend? and how will you know which mg per compound? If you're getting sides-how will you know if it's from Tren or Mast? IMO, I rather draw separately-thus knowing how much of each..

 

[jJjburton]

I would run seperate vial of tren A and test. That is all you need. Tren A at 500 or more, is unbelievable. Test low or high depending on lean or bulk.