Ora plus (anadrol)

[rigs03]

What's up guys, just wondering if anyone has experience using ora plus in order to make liquid oral drol?

Is it really as easy as just mixing together and shaking, or a bit more complicated than that? Any heating involved?

I have 15g raw powder and looking to to mix in order to take 50mg doses. New to this and was caught off guard with raws instead of tabs, so Any experiences or tips would be greatly appreciated!

 

[XKawN]

No heating. heating would be for making a liquid solution (completely dissolved into liquid). what you would be making is a suspension . imagine a snow globe affect. Shake the liquid/powder mixture before each use to temporarily mix the products immediately before drawing with a oral syringe and using. here is an example of what I would do. if I had 60ml bottles I would fill with one with 60 ml of water. visually mark the bottle, empty, dry. now I know where the 60ml point is on all my bottles. fill them half way with ora plus and add desired amount of raw powder. I would shake well then fill them the rest of the way with the ora plus and there you have it.

 

[rigs03]

Thanks @XKawN !

What would be an upper limit of how raw powder per ml? I'm assuming too much would cause it not to properly suspend?

I was thinking 2.5g powder per 60ml, to make ~40mg per ml doses ( 2500/60=41.68 ) ... am i thinking of this correctly?


Sent from my iPhone using Tapatalk

 

[XKawN]

Thanks @XKawN !

What would be an upper limit of how raw powder per ml? I'm assuming too much would cause it not to properly suspend?

I was thinking 2.5g powder per 60ml, to make ~40mg per ml doses ( 2500/60=41.68 ) ... am i thinking of this correctly?


Sent from my iPhone using Tapatalk

I think the lower the dose the more accurate you can be. I, personally, go about 25 to 30 mg per ml.