Please help carrier oil

daylight driller

New Member
AnabolicLab.com Supporter
I am wanting to cut some test 500 to get rid of the pip. Should i get gso from the grocery store and then filter it with a watman 22? Or what is the best way. Sorry for a newb question but ive never brewed or cut a hormone with oil. I also found filtered gso on ebay but dont know if i could trust that. Thank you for your help (next time ill bet the test 300)
 
You have to make sure it doesn't have any additives, but yes you can get from grocery store if necessary. Filter with .2um filter.
 
If you're diluting an existing mix, just add the oil. And like stated, many off the shelf contain additives. Pure is the way to go. Don't forget the .22.
 
About to order some watman .2 syringe filters and usp gso. If i mix 10ml of gso and 10 ml test 500 in a presterile vial filtering though the watman .2 do i need to bake it in the oven or would that be good enough. Also thanks for all the help
 
As long as your brew is already clear with no crystals or other visible solids, simply mix and filter. Not knowing your brewer, I'd filter the 500 into a vial half filling it, then filter the GSO filling the other half. Use an 18 pin to inject, and an open 18 to vent. This will make 250. Shake well and shoot. You're done, and you know it's filtered while previously it wasn't.

Be prepared for a workout as the .22 filter isn't thumb friendly. Don't overdo it, either, or you'll trash the filter.
 
Its pharmacoms test e 500, although i believe i will filter it as well just for piece of mind. I just ordered some usp gso oil, 10 watman .2 syringe filters and after reading up on filtering i think im going to order some 60ml syringes so i can put it in a caulking gun since i have 6 vials to filter and dilute.
 
Back
Top