MESO-Rx
Anabolic Steroids
QSC NPP 100mg/ml, I would like to increase it to 200mg/ml, carrier MCT not sure if it has any EO. I have raw npp.
- Thread starter beh
- Start date
narta
Member
Nope.
Spaceman Spiff
Subscriber
How are you going to increase it? Do you have raws?
He has. He said right and the end of the title. You can probably do 150mg/ml but 200 if could be done will cause you high pip and high inflation because of eo. How much npp are you running?
Spaceman Spiff
Subscriber
Fuck my life
You can better brew the other raws. You have to use a little heat to dissolve the npp and the oil already contains bb and ba. You can better not heat the bb and ba as they can react or boil out of the solution(ba).
You can also brew 200mg/ml npp. If crashed or bad pip dilute it with the qsc oil you have so you won’t waste anything.
There should be no reason why you can't inject 3cc in most muscle groups...Vg, front delts, lats. For things like rear and front delts, chest, just split the shot between left and right sides. If your muscles aren't big enough to accommodate this then maybe you don't need as much?
nightprowler7
Member
I did this once and it worked fine. I emptied some vials from another vendor in a beaker and added raws. Filtered into a sterile vial and injected it
Of course you can add raws to already brewed oils.
The issue though is in calculating what your end finished product actually is....
You taking a guess at what the original BA/BB Vol is in QSC's brew, sure you know the raw volume they used.
Now your trying to brew an existing brew of NPP from 100mg/ml to 150mg/ml... NPP is a bitch to get to hold in solution much above 120mg/ml, your going to need to dramatically increase the BB at the very least and your working on a guess as to what QSC used in theirs. Realistically though, your going to need to use something like EO and again, your just guessing as your working from a guess what's in the QSC brew to begin with.
Honestly, as others said, use your raws and brew from scratch. Then you know exactly what you have done and if its needs adjustment, your working from a known point.
The issue though is in calculating what your end finished product actually is....
You taking a guess at what the original BA/BB Vol is in QSC's brew, sure you know the raw volume they used.
Now your trying to brew an existing brew of NPP from 100mg/ml to 150mg/ml... NPP is a bitch to get to hold in solution much above 120mg/ml, your going to need to dramatically increase the BB at the very least and your working on a guess as to what QSC used in theirs. Realistically though, your going to need to use something like EO and again, your just guessing as your working from a guess what's in the QSC brew to begin with.
Honestly, as others said, use your raws and brew from scratch. Then you know exactly what you have done and if its needs adjustment, your working from a known point.
Similar threads
