question for all kitchen chemists

[jocko]

Hey bros, I am trying to turn my powder into a liquid suspension to move it from point a to point b then i want to heat the suspension via microwave or stovetop to get it to evaporate and in the end just have the original powder substance...THe question i have is what liquid chemical can i use to obtain this?? thanks for all replies

 

[Mountain]

what is the chemical and what is it suspended in?

I am not trying to pose as an expert, but I may be able to help if I knew if it was oil, water or other.

I know that either is often used to achieve your goals.

The next question I would ask is, "What are you planning to do with the powder once you get it back to a powder?" The answer to this will affect what you can use to get it out of the liquid.

Hope I can help,

Mountain

 

[jocko]

the chemical is clomid. i would rather suspend it in something non-flamable when i am done with getting the raw powder back i will transfer it into capsules. thanks

 

[jocko]

bump

 

[panteracfh]

why not leave it suspended, and put it in caps while its in liquid? Just get empty caps and squirt it in and close em, i do it all the time with liquids that taste bad... easy too, i can get like 100 done in 10 min... unless you have to cap like a few thousand that should be fine, alot easier than suspending, getting it back and doing all that shit... youknow....anyway, thats my suggestion...

 

[DoiMiNioN]

I think distilled water or bacteriostatic water would do the trick but then you would have to evaporate the water at a slow rate to get the percipate out. But would thischange the chemical structure or clomid? who knows.. i say its easier to ship via poweder cause you would need ALOT of water to completely dissolve the powder.

 

[jocko]

I think distilled water or bacteriostatic water would do the trick but then you would have to evaporate the water at a slow rate to get the percipate out. But would thischange the chemical structure or clomid? who knows.. i say its easier to ship via poweder cause you would need ALOT of water to completely dissolve the powder.

can i use a little ba and bacteriostatic water and get the powder back out in a microwave? thanks