Syringe & Needle Size

For larger dose cycles, do you guys typically use 2ml syringes? And if so, what gauge needle would work best with this size syringe?

I used 3ml syringes in the past, but had issues with it being extremely hard to inject the compound.

I typically use insulin needles as I run lower doses now but was looking to increase my doses and was just hoping to get some advice on what size syringes and what gauge needles you recommend

Thank you
 
2.5-3 ml 25 ga 1 in needle I can do just about what ever I need to with that size, bigger syringe should be easier to Inject than with a small needle in my opinion. Mabe u had something with a thick carrier oil.
 
I have never injected over 2 cc at once. Really I feel like I gota squeezed harder with a 25 1 in than a 23 ga 1.5 in not that I mind.
 
Now that everything is made with mct as a carrier the 27g 1 1/4" I have is easy peezy
I wana get some 27 do they have a 1in? I'm all about reducing scare tissue, I rotate spots alot and deep tissue massage the spots pin.
 
Most people draw with an 18g then switch out to their pin needle. It's easier and the pin needle stays sharp.
Ive tried that w a 20g. By the end of the bottle the rubber stopper wasn't looking to good so just stuck with 25g for both. Sometimes I'll swap on a new needle but usually don't notice a difference
 
Ive tried that w a 20g. By the end of the bottle the rubber stopper wasn't looking to good so just stuck with 25g for both. Sometimes I'll swap on a new needle but usually don't notice a difference
There's a lot of area on that rubber stopper so you never have to poke the same spot twice. Now it's a different story if your using 30ml bottles.
 
I draw with a 20g, I have used 18 before but i got stopped in the barrel sometines. I think its too big to draw imo wfter getting stopper in the barrel. But I use a 25g 5/8in to shoot now but i used to use 23g 1in for years until i found out that they make these 25g 5/8in. 23g 1 in that shit goes in quick. always used 3cc barrel and filled that motherfucker and pinned eod if i pin something ed ill used a 29g 1/2 slin pin if i can find 27g 1/2 in ill use that. play around with this until you find a size you like. Ill warn you the 23g 1 in is too big for most guys theyd op for the 25, which is nicer, but i also shoot gear thats in EO and its thin so it goes it smooth.

Edit: if you have bodyfat id suggest using at least a 1 in needle. if super lean you can use the 5/8 in but i always bury it so it gets about an in deep.
 
Some of you all are still drawing with the same needle you shoot with? Swap needles so you’re using a sharp point and not just ripping into your muscle like a fucking Neanderthal.
 
Some of you all are still drawing with the same needle you shoot with? Swap needles so you’re using a sharp point and not just ripping into your muscle like a fucking Neanderthal.
hey man i dont think it dulls it that much haha bro i sold gear to this dumbshit dude wonce and he tried to put the needle thru the plastic flip off top he calls me hes like dude how do i get this shit out of the bottle i go over there and the dumbass had he needle jammed into the plastic flip top hahahaahaha fucking people
 
Back
Top