Test c recipe

Evom1

Member
10+ Year Member
Super basic question, just want opinion

I've seen test cyp 250mg using
2%ba 10%bb
and
2%ba 15%bb recommended.

What's the preferred recipe? Obviously don't want it to crash, but minimal pip if possible.
 
250mg at 10%BB? Mmm...may crash. Kinda borderline actually. You in a warm climate?
Unfortunately no. That's why I was concerned 10 might be too low. Still very much sweatshirt weather here
 
Unfortunately no. That's why I was concerned 10 might be too low. Still very much sweatshirt weather here
I have to hit at least 15% or 250mg/ml or higher crashes when it gets cold. Couldn't hurt to let it sit around a while before you filter it after brewing, wait and see what it does. I know your hood, it's sweatshirt weather my ass! You guys get snow with that last little storm?
 
I have to hit at least 15% or 250mg/ml or higher crashes when it gets cold. Couldn't hurt to let it sit around a while before you filter it after brewing, wait and see what it does. I know your hood, it's sweatshirt weather my ass! You guys get snow with that last little storm?
Hah well on my drive home it just said tonight is going to be snow and sleet which sucks!

15% I'm pretty sure is what I did last time and it worked
 
Hah well on my drive home it just said tonight is going to be snow and sleet which sucks!

15% I'm pretty sure is what I did last time and it worked

Just an FYI-if you overdose your gear by 10% like I do, you may run into problems with Test C 250. It will hold at 250, but becomes very iffy at 275. I've had it crash at 275 with 19/1.
 
Has anyone brewed Test Enanthate without Benzyl Benzoate? Does it come out too thick or is it ok? I will use either Mct oil or Peanut oil, probably Peanut.
 
Back
Top