tren ace/basskiller

[IronBrothers]

So I dialed in the calc on basskiller for 50ml of trenA at 100mg/ml
Added 5g TrenAce
2% BA -1ML
20% BB - 10ML
And calls for 34ML of carrier oil
I added 27ml of oil and the 50ml mark on my beaker is on the line... should I add the remaining 7ml of mct?

 

[Casshern]

Beaker markings are probably off. I have a couple of little 100mL ones that read about 55 with 50 in there, shitty things. My bigger ones read a bit better, but even the 250mL one moves so little with a few added ml's that it's hard to get an accurate reading. They're usually only aprox. which makes proper graduated cylinders useful for fluid measuring.

If you were pretty exact with the sryinge work, I'd pick you're probably under on volume and should add the 7mL

 

[IronBrothers]

Bah.. kinda butchered this batch. Following my beaker was a bad idea. After I distributing gear into vials, I then distributed the remaining 7ml between the vials. Had some swirls going first couple times I heated the vials, but eventually went away.

 

[IronBrothers]

Should be pretty close to on dose though. Problem is, report on these tren ace raws has been low for many. Somewhere around 50%. So pinning 1ml tren ED is probably going to be rough when the time comes.