Deca crashed

[T_verde77]

Crashed deca 300mg/ml. What should I do?

I made a batch of deca. all the small vials are still fine but I just put the left over in the larger vial that still had some deca from a previous batch inside. it goes clear when I heat it up but than goes back to really cloudy.

And before adding the new deca..the old stuff was fine, and also it was very old. Most likely I will just throw it out but figured I'd ask.

Thanks

 

[bill9799]

Wouldn't want to put that into my body.

 

[Big_poppa_Bren]

Add a few ml of BB and see if it holds.

 

[T_verde77]

Add a few ml of BB and see if it holds.

Thanks bud. I figured that would be the best way to go about it

 

[Docd187123]

Thanks bud. I figured that would be the best way to go about it

Deca at 300mg/ml should not require BB. Did the ambient temps drop at all? Maybe your raws are suspect? What recipe did you use? Just reheat it with mild/moderate heat for a few min and see how it holds. If you have to do it before each pin so be it.

 

[T_verde77]

Deca at 300mg/ml should not require BB. Did the ambient temps drop at all? Maybe your raws are suspect? What recipe did you use? Just reheat it with mild/moderate heat for a few min and see how it holds. If you have to do it before each pin so be it.

It does not hold for very long. Only stored at room temp. I think I used a different type carrier oil for the first batch. Maybe that is what caused it. Like I said the actual batch is perfectly fine, just the left over that I mixed with some older deca

 

[nophat]

Sounds like a little moisture was in the vial.
What did you use for oil?
EO will do this sometimes

 

[T_verde77]

Sounds like a little moisture was in the vial.
What did you use for oil?
EO will do this sometimes

I've used sesame and grape seed before in the batches.

 

[Big_paul]

There is moisture in your vile. Nasty looking gear. I wouldn't use that.

 

[Jakan]

Looking like mix of inj. winny with other oil based stuff there is water in your oil.

 

[Andre silva]

Deca at 300mg/ml should not require BB. Did the ambient temps drop at all? Maybe your raws are suspect? What recipe did you use? Just reheat it with mild/moderate heat for a few min and see how it holds. If you have to do it before each pin so be it.

Help me understand ... The deca 300mg not need bb, why?

 

[Docd187123]

Help me understand ... The deca 300mg not need bb, why?

Bc deca is very soluble and doesn't require a solvent for typical concentrations.

 

[Jakan]

Thats reason why some powders, specialy in summer, are more like paste or piece of stone. Testosterone Enan and mix, newer got them like powders haha.