Syringe and Needle Dimension Question for First Cycle

[Azy]

I've been reading around on the preferred dimensions/units of the syringe and needle for different injection locations.

I'm planning on trying glutes first and then quads and so on until I find out what I am most comfortable with. Planning on injecting Test E and potentially Primo E as well.

From what I'm reading, it's preferred to use 25 gauge in general (some varying viscosity oils will require lower or higher gauges of course). As for the needle length, I'm seeing varying opinions on whether to use 1 or 1.5 inch for glutes, and for the other locations, I'm seeing things like 1 inch for quads & delts, and other locations 1/2-1 inch.

Just wondering if anyone can clear up the question about preferred needle length for glutes, and any other general advice I might be missing otherwise. Thanks

 

[Silentlemon1011]

For the guys that fear 25g or pins in general,
I can really feel you..

You could go that way...

take your weekly dosage of your fav gear/ stack... let it solve in BB and BA at your selected ratio, once you have it, filter and fill a condom with that solution.

be sure that amount of oil is enough to fill it like a big penis would do.

then, put it in a deep freezer and let if freeze.

once frozen , ( this story isn’t related to my nickname, that Frozen part of nickname is related to my heart... </ /3 ) , remove the condom and you ll have a frozen penis shaped sculpture made of oil and gear...

Well, close your eyes and open you ass...

You ll have a very pleasant extended-release amount of gear that will have you covered for a week, without that horrible and stressing thought of pinning your pinky and peach scented skin..


You should have something similar

View attachment 144791

(Picture by courtesy of @Silentlemon1011)

Suppository Gear?!?!
Do you make Trensicles?

May as well get ahead of the Tren fucked up thoughts on day one

You should patent that shit

 

[RoidRage420]

For the guys that fear 25g or pins in general,
I can really feel you..

You could go that way...

take your weekly dosage of your fav gear/ stack... let it solve in BB and BA at your selected ratio, once you have it, filter and fill a condom with that solution.

be sure that amount of oil is enough to fill it like a big penis would do.

then, put it in a deep freezer and let if freeze.

once frozen , ( this story isn’t related to my nickname, that Frozen part of nickname is related to my heart... </ /3 ) , remove the condom and you ll have a frozen penis shaped sculpture made of oil and gear...

Well, close your eyes and open you ass...

You ll have a very pleasant extended-release amount of gear that will have you covered for a week, without that horrible and stressing thought of pinning your pinky and peach scented skin..


You should have something similar

View attachment 144791

(Picture by courtesy of @Silentlemon1011)

Can I insert this myself or should I have my gym buddy do it for me?

 

[Cashton]

I've been reading around on the preferred dimensions/units of the syringe and needle for different injection locations.

I'm planning on trying glutes first and then quads and so on until I find out what I am most comfortable with. Planning on injecting Test E and potentially Primo E as well.

From what I'm reading, it's preferred to use 25 gauge in general (some varying viscosity oils will require lower or higher gauges of course). As for the needle length, I'm seeing varying opinions on whether to use 1 or 1.5 inch for glutes, and for the other locations, I'm seeing things like 1 inch for quads & delts, and other locations 1/2-1 inch.

Just wondering if anyone can clear up the question about preferred needle length for glutes, and any other general advice I might be missing otherwise. Thanks

1 inch 25 to inject and a 21 to draw ! Standard brother.

 

[Jestopherson]

Can I insert this myself or should I have my gym buddy do it for me?

Always seek the help of a friend. Ensures success and its a great team exercise

 

[RoidRage420]

Always seek the help of a friend. Ensures success and its a great team exercise

Thanks bro. Can I practice on you first? I've never done this before

 

[Stphnhrrng]

I get the 3cc syringes with a 1” long 22g needle to draw it, and then I buy 1” 25g tips to switch for the injection once it’s already drawn

 

[Jestopherson]

Thanks bro. Can I practice on you first? I've never done this before

I dunno.. are we ready to take that step and be friend official?

 

[Cumminstech]

Every syringe is luer lock except the ones with the non detachable needle for HGH/HCG

Cruise
Draw all with 25g.

Test p 100mg/ml EO, 20%BB 2%BA
Pin 30g 1 inch
1cc syringe
Test c 200mg/ml GSO or EO, 20%BB 2%BA
Pin 27g 1 inch
1cc syringe
Test u 300mg/ml EO, 20%BB 2%BA
Pin 27g 1 inch
1cc syringe

Blast
Draw all with 25G.
Except EQ with 23G.
600mg/ml EO, 20%BB 2%BA
Except Tren hex with 23G.
150mg/ml GSO, 20%BB 2%BA

Tren E/Test C/Mast E all at 200mg/ml EO, 20%BB 2%BA.
Pin 25g 1 inch
3cc syringe

Primo E 250mg/ml EO, 20%BB 2%BA
Pin 25g 1 inch
3cc syringe

Tren A/Mast prop/Test prop EO, 20%BB 2%BA
Pin 27g 1 inch
3cc syringe

Tren A/Mast prop/Test prop MCT, 20%BB 2%BA
Pin 25g 1 inch
3cc syringe

EQ 600mg/ml EO, 20%BB 2%BA
Pin 23g 1 inch
3cc syringe

Tren hex 150mg/ml GSO, 20%BB 2%BA
Pin 23g 1 inch
3cc syringe

HGH Pin and draw 30g non detachable needle.
HCG same syringe as HGH.
12mm needle I think.
1cc syringe.

Location doesn't change a thing regarding length of needle at my BF. 1 inch.
I have never pinned my ass. No clue.

Drawing with 25g due to countless fuck ups with the rubbers.
I am using big vials. Not 10ml.

You make primo at 250mg/ml? Does it hurt? That’s the highest primo dose I’ve seen. I’ve been trying to find 200mg/ml from a reputable canadian domestic lab and have had no luck.

 

[TrennedOutLunatic]

You make primo at 250mg/ml? Does it hurt? That’s the highest primo dose I’ve seen. I’ve been trying to find 200mg/ml from a reputable canadian domestic lab and have had no luck.

Pip 3/10 for 72h
3cc solo primo injection,not mixed with anything else.

Primo 300mg/ml is possible too. A friend of mine did it. He could not pin it.
Miglyol 840 unknown bb and ba, Hold.

 

[Cumminstech]

Pip 3/10 for 72h
3cc solo primo injection,not mixed with anything else.
View attachment 144797
Primo 300mg/ml is possible too. A friend of mine did it. He could not pin it.
Miglyol 840 unknown bb and ba, Hold.

I probably wouldn’t attempt 300mg/ml primo lol. 250mg is fine enough for me. 750mg a week with 1200 test is an ideal cycle for me, but if I was pinning 100-150mg/ml primo then that becomes a lot of oil.

 

[Aellonfol]

Man if you can pin quads, more power to you. I cannot. The pinning itself goes fine, I am relaxed and there is zero pain. But using the same needles and pulling oils out of the same vial as used in my glutes, pinning my quads causes MASSIVE pain about 12 hours after pinning.

Last time I did it (I have pinned quads 3 times, and this actually happened each time), I had a large (about 6" radius) hot red circle around the injection side that lasted for about 4 days and made is really hard to even walk. There was no contamination and no allergic reaction to the oils, my quads just don't fucking like it at all.

With that said, I use 1", 25g in glutes and quads, and 5/8" 25g in delts. I'm thinking about rotating lats into it.

I had this too until I switched to only pinning quads when sitting up in bed so they’re totally relaxed. No issues since

 

[muscletrain]

I've been reading around on the preferred dimensions/units of the syringe and needle for different injection locations.

I'm planning on trying glutes first and then quads and so on until I find out what I am most comfortable with. Planning on injecting Test E and potentially Primo E as well.

From what I'm reading, it's preferred to use 25 gauge in general (some varying viscosity oils will require lower or higher gauges of course). As for the needle length, I'm seeing varying opinions on whether to use 1 or 1.5 inch for glutes, and for the other locations, I'm seeing things like 1 inch for quads & delts, and other locations 1/2-1 inch.

Just wondering if anyone can clear up the question about preferred needle length for glutes, and any other general advice I might be missing otherwise. Thanks

Depends how fat you are, 1 inch for me works everywhere. Non blasting I just backlock slin pins and shoot that. If not I'll just run 25g 1 inchers.

 

[TrennedOutLunatic]

I probably wouldn’t attempt 300mg/ml primo lol. 250mg is fine enough for me. 750mg a week with 1200 test is an ideal cycle for me, but if I was pinning 100-150mg/ml primo then that becomes a lot of oil.

200mg/ml ftw.
No need for more concentration.

 

[RomanMVP]

No, go ahead and pin your quads, I've been doing it for years. Just heat up your oil and you're GTG. It's no fucking big deal!

 

[MFAAS]

I draw back with a 25g then swap the tip out for a 28g 1/2" and pin with that. Works great, less tissue damage. For low volume injections I often will just use a 29g 1/2" slin pin. I don't pin glutes though, I pin VG and I have almost zero fat over my VG, so it's really easy to access. I have pinned dorsoglute in the past with the same 1/2" length and been fine, also have very little fat there.

From what I'm reading, it's preferred to use 25 gauge in general (some varying viscosity oils will require lower or higher gauges of course). As for the needle length, I'm seeing varying opinions on whether to use 1 or 1.5 inch for glutes, and for the other locations, I'm seeing things like 1 inch for quads & delts, and other locations 1/2-1 inch.

Just wondering if anyone can clear up the question about preferred needle length for glutes, and any other general advice I might be missing otherwise. Thanks

 

[AlwaysHungry]

23g x 1 inch in delts, going 4/4 since THERE IS MEAT B-)

now I’m pinning 3 x week just delts.. in the past just gluteus’

from now on, just delts for ever... because I hope in some kind of localized depot and so on..

Keep me dreaming , don’t wanna read It goes systemic bla bla bla

and I pin HGH ED in delts with insulin syringe 0.5ml with a micro needle, 1/3 of that of 1ml insulin syringe..

I used to pin quads too but then had some bad pip that prevented me to stay awesome so, delts... only delts... 23g is more pain than 25g you pheggez, No pain No gain

Pin boldenone and npp on your shoulders you will thank me later

 

[Silentlemon1011]

I probably wouldn’t attempt 300mg/ml primo lol. 250mg is fine enough for me. 750mg a week with 1200 test is an ideal cycle for me, but if I was pinning 100-150mg/ml primo then that becomes a lot of oil.

Wish we had good 200mg Primo in Canada
I only know of Nordic that Carrie's it and he throws Gauicol in it, apparently the PIP is nasty too.
No thanks
I also dont understand how the fuck we cant get 100mg Tren Ace without Gauicol in Canada, what the fuck

I REALLY have to start brewing, just for Primo at 200mg,

 

[Jestopherson]

Wish we had good 200mg Primo in Canada
I only know of Nordic that Carrie's it and he throws Gauicol in it, apparently the PIP is nasty too.
No thanks
I also dont understand how the fuck we cant get 100mg Tren Ace without Gauicol in Canada, what the fuck

I REALLY have to start brewing, just for Primo at 200mg,

That's exactly what the driving factor for me is. Cheap(er) primo. Ya I'm honestly surprised inno hasn't done it with all the other shit he has haha.

 

[TrenBolognaSandwich]

23g x 1 inch in delts, going 4/4 since THERE IS MEAT B-)

now I’m pinning 3 x week just delts.. in the past just gluteus’

from now on, just delts for ever... because I hope in some kind of localized depot and so on..

Keep me dreaming , don’t wanna read It goes systemic bla bla bla

and I pin HGH ED in delts with insulin syringe 0.5ml with a micro needle, 1/3 of that of 1ml insulin syringe..

I used to pin quads too but then had some bad pip that prevented me to stay awesome so, delts... only delts... 23g is more pain than 25g you pheggez, No pain No gain

This man gets it, I pin 23g at the latest every 2nd day myself. Quads are good to rotate on but you got to feel out the spot as I had one bad pip for a week straight in the past myself but can't be a bitch and cry about it if you sign up to stick a needle into yourself in first place lol

 

[Silentlemon1011]

That's exactly what the driving factor for me is. Cheap(er) primo. Ya I'm honestly surprised inno hasn't done it with all the other shit he has haha.

I think he has 150mg Primo E at a decent price, but I want 200mg with minimal PIP lol