how difficult would it be to weigh single digit/fractions of milligrams?

[steckdose0]

i'm sick and tired of taking razor blades to AI's trying to cut them up into quarters.. i'm too old for this shit. i hate it so much that this is one of the reasons i stopped taking high doses of test.

instead of trying to cut those little pills up i figured i would just crush it up and weigh it out and then cap the powder. but how would you measure something as light as 250mcg accurately such as .25mg or arimidex? it's such a little amount of powder that it can even be residue.

any insight is appreciated. thanks.

 

[H&M]

crush the pills as fine as possible (ex.:strip of tabs with coffe grinder) make a suspension and measure

 

[MFAAS]

Volumetric dosing is the answer, as H&M explained above. Google for more info.

You will not be able to get a scale accurate enough to weigh fractions of a mg. Unless you can spend thousands of dollars. There are also the variables that need to be mitigated. At that level even the movement of air could affect your measurement. Or if your table is not level. Etc. Volumetric dosing is the only way.

 

[Norse13]

i'm sick and tired of taking razor blades to AI's trying to cut them up into quarters.. i'm too old for this shit. i hate it so much that this is one of the reasons i stopped taking high doses of test.

instead of trying to cut those little pills up i figured i would just crush it up and weigh it out and then cap the powder. but how would you measure something as light as 250mcg accurately such as .25mg or arimidex? it's such a little amount of powder that it can even be residue.

any insight is appreciated. thanks.

You don't need to weigh up 250mcg. The active ingredient is mixed with large amounts of inert binding agents to make a sufficient volume to be pressed into a tablet. That one tablet is primarily binding agents, just a tiny bit AI. You can't separate the ingredients out afterwards.

It would be a different story if you were to buy 100% raw powder, but few people do that.

I just use a nail clipper for toe nails, it's usually easy to split tabs in half. Quartering is a bit more challenging to get precise since the half-tabs start to crumble up.

 

[steckdose0]

crush the pills as fine as possible (ex.:strip of tabs with coffe grinder) make a suspension and measure

Volumetric dosing is the answer, as H&M explained above. Google for more info.

You will not be able to get a scale accurate enough to weigh fractions of a mg. Unless you can spend thousands of dollars. There are also the variables that need to be mitigated. At that level even the movement of air could affect your measurement. Or if your table is not level. Etc. Volumetric dosing is the only way.

so i just crush it up and dissolve it in alcohol? and it would be evenly distributed throughout the concentration if i shake it up before every use ?

 

[MFAAS]

so i just crush it up and dissolve it in alcohol? and it would be evenly distributed throughout the concentration if i shake it up before every use ?

yep that's the way. Idk if alcohol is the correct solvent for this substance but yeah you got the gist of it man.

 

[MFAAS]

Just make sure you fully empty the dropper after shaking so you get freshly mixed liquid in there.

 

[TheHaus88]

I've seen .25mg Adex, just need to shop around.

Oral suspension might be the way you want to go, some stuff doesn't work. I tried suspending Telmisatan but it clumped.

 

[H&M]

To be honest you need to find the best solvent for your APi,dissolve copletely,and you got a solution.Or make suspension,but this need to shake everytime before use.

 

[millesteg]

I just use a nail clipper for toe nails, it's usually easy to split tabs in half. Quartering is a bit more challenging to get precise since the half-tabs start to crumble up.

That souns pretty nasty if its the same nail clipper you use for your toes lmao
Just get a pill splitter theyreike 2$.

 

[klokke23]

You don't need to weigh up 250mcg. The active ingredient is mixed with large amounts of inert binding agents to make a sufficient volume to be pressed into a tablet. That one tablet is primarily binding agents, just a tiny bit AI. You can't separate the ingredients out afterwards.

It would be a different story if you were to buy 100% raw powder, but few people do that.

I just use a nail clipper for toe nails, it's usually easy to split tabs in half. Quartering is a bit more challenging to get precise since the half-tabs start to crumble up.

Few people buy oral raws what?

 

[Norse13]

No

Few people buy oral raws what?

Few people buy 100% undiluted raws of chemicals which are normally dosed in micrograms. E.g. buy a bag of T3 and try to measure 20mcg... Good luck in that.
OP asked about arimidex and compounds dosed in micrograms, not anadrol or tadalafil.

I'm of course keen to learn if you have a good way to measure micrograms safely, accurately and at reasonable cost.

 

[MadBret]

If you're going the suspension route, ora-plus or humco would probably be better and more tolerable than high proof liquor.

 

[klokke23]

No

Few people buy 100% undiluted raws of chemicals which are normally dosed in micrograms. E.g. buy a bag of T3 and try to measure 20mcg... Good luck in that.
OP asked about arimidex and compounds dosed in micrograms, not anadrol or tadalafil.

I'm of course keen to learn if you have a good way to measure micrograms safely, accurately and at reasonable cost.

My mistake