MESO-Rx
Anabolic Steroids
Max concentrations
- Thread starter Rurdbuk
- Start date
deeeznuts
Member
I think it's 250 for test C, I don't know about the others though.
eery
Member
In mct in aware that mastE will hold at 250, NPP at 150 and testC at 250 with 20/2 bb/ba.
I wouldnt recommend NPP at 200, thats going to give you a lot of PIP in most cases.
GSO might be 200/100-125/250, as its thicker and less soluble, but im not sure.
I wouldnt recommend NPP at 200, thats going to give you a lot of PIP in most cases.
GSO might be 200/100-125/250, as its thicker and less soluble, but im not sure.
Villain
Member
I’ve seen Test C at 300 and even higher and Mast E at 400. NPP definitely no more than 150.
How about 250 for the test (1/20) , 200 for mast (1/20) and 150 for NPP (1/20)
In GSO?
eery
Member
Im not that sure about the 150 NPP though, but it should work.
Villain
Member
MCT
I’ll consider MCT then if it’s got a better chance of holding it. I just know I have no problems with GSO so was reluctant to change. Last and only brew was test e with GSO.
I could lower it but need to consider injection volumes. Next blast is a low dose so might be ok
Villain
Member
MCT is the way to go for higher concentrations but Mig is even better from what I understand.
notanothersnake
Member
Npp def holds 200 in mig and without bad pip.
You need to stop considering each individual compound and think of them cumulatively. If you take 2 compounds that will only hold up to ~250, you can't expect the solvents to disolve both of those compounds at that concentration.
AND if it did hold, you wouldn't be able to use it.
You need to stop considering each individual compound and think of them cumulatively. If you take 2 compounds that will only hold up to ~250, you can't expect the solvents to disolve both of those compounds at that concentration.
AND if it did hold, you wouldn't be able to use it.
They are all being mixed individually, sorry if that wasn’t clear.
What is mig?
Villain
Member
Miglyol.
Thanks. Just found out I have used MCT in the past without issue so think I’m gonna go for that.
Planning , test c @ 250, mast e @ 300 and NPP @150 using MCT . Probably 2/20 for the lot
Is this any good?
MCT Oil | Premium Oil Sourced 100% from Coconuts | Bulk™
Shop Bulk™ MCT Oil - premium 100% coconut-sourced oil with 60% C8 & 40% C10. Keto-friendly, high energy, perfect for DIY formulas. Bulk™, formerly Bulk Powders.
www.bulk.com
Villain
Member
That should definitely suffice or the NOW brand of you can get it where you are.Is this any good?
MCT Oil | Premium Oil Sourced 100% from Coconuts | Bulk™
Shop Bulk™ MCT Oil - premium 100% coconut-sourced oil with 60% C8 & 40% C10. Keto-friendly, high energy, perfect for DIY formulas. Bulk™, formerly Bulk Powders.www.bulk.com
For anyone who is interested I brewed up the NPP and mast e today , not the test c as still have a fair amount of test e left
Took me an hour to brew up 10 grams of each, 250mg/ml mast e (2/22) and 125 mg/ml of NPP (2/22).
All went well, NPP Needed heating a litttle more to get it mixing in (I stirred by hand in a pyrex jug. Filtered by hand using syringe filters.
Pinned my test e, npp and mast e this afternoon, nice and smooth so far!
Took me an hour to brew up 10 grams of each, 250mg/ml mast e (2/22) and 125 mg/ml of NPP (2/22).
All went well, NPP Needed heating a litttle more to get it mixing in (I stirred by hand in a pyrex jug. Filtered by hand using syringe filters.
Pinned my test e, npp and mast e this afternoon, nice and smooth so far!
