Anyone just weight their oils?

  • Thread starter Thread starter Deleted member 123722
  • Start date Start date
D

Deleted member 123722

Guest
Brewed 100ml of Deca last night. Usually I take my 10ml syringe, and extract the exact amount of oil to add into the raw/solvents, but yesterday I decided to just measure the oil by weighing it on my food scale; it turned out I overshot about 2ml, (102ml total) making my Deca 194mg per CC. Even doing it the other way, I tend to lose ML through filtering or whatever else, so this small "loss" is no biggie, and saved a shit load of time lol.

Anyone else do this?
 
Brewed 100ml of Deca last night. Usually I take my 10ml syringe, and extract the exact amount of oil to add into the raw/solvents, but yesterday I decided to just measure the oil by weighing it on my food scale; it turned out I overshot about 2ml, (102ml total) making my Deca 194mg per CC. Even doing it the other way, I tend to lose ML through filtering or whatever else, so this small "loss" is no biggie, and saved a shit load of time lol.

Anyone else do this?
Allow me to save you even more time. Buy a graduated cylinder from a name brand company such as medlabsupply and measure your oil that way.
 
Allow me to save you even more time. Buy a graduated cylinder from a name brand company such as medlabsupply and measure your oil that way.
yea but I've heard they aren't always accurate, that weight is much more?
 
So you trust a kitchen scale you probably bought at Walmart over a graduated cylinder made by a scientific supply company?
Amazon actually.

But what I did before I tried this method, was I poured and weighed 3ml, then took my syringe to extract 3ml to make sure it was accurate, and it was.

But anyway, if the graduated cylinder is accurate, then fuck yes I'd do it lol. Have you made sure it is?
 
Last edited by a moderator:
Back
Top