MESO-Rx Sponsor Genuine Steroid Powder Manufacturer-AASraw

[justtrtbro]

So essentially thats kinda what I was asking. I just do 10% by default and if its over… just enjoy the gains! Lol

I hear you. Personally I prefer as close to intended concentration as possible. The sample tested, should it indeed be a good representation of the batch, will indicate how much to overdose it by to be as near as possible the target.

10%+ might make sense for uh.. a recent batch in here, ~12.35% overdosed would have likely done it in that case.

Edit - if the batch was a person it'd be slightly dehydrated

 

[justtrtbro]

Honestly, I wonder if sense they did all the shut downs if the police took all of a certain chemical they were using to synthesize the raws & this factory is using a different chemical in its place that does the same job as the old ingredient to synthesize the raws that’s making the yellow tint & the difference in smell. Kind of like in breaking bad the blue meth .

Respectfully I doubt it. They're more likely just cutting corners, probably to speed the process a bit. That and using less than preferred raw materials for synthesis.

 

[B Ware]

Isn’t there always a variance with all jano tests? I would rather have it over than under. And for those that don’t test their actual raws, but go off of what someone else tested it as. Think a 10% overdose wouldn’t hurt. And you also account for any kind of loss that could happen with oils getting stuck in the filter or in any beaker/graduated cylinders you may use.

Like mentioned, it would look sloppy. +10% would have put my end result at 275mg/ml. If I was shooting for 300mg/ml with the added +10% the end result would have been 330mg/ml. Personally I like to meet a desired label claim.

Not following on adding +10% accounting for oil loss, which is very little. I personally see a -1% loss using a capsule filter. How does adding +10% of raws do anything for lost oil? You just have less oil that is still not meeting label claim.

 

[watchtymeflyyy]

Like mentioned, it would look sloppy. +10% would have put my end result at 275mg/ml. If I was shooting for 300mg/ml with the added +10% the end result would have been 330mg/ml. Personally I like to meet a desired label claim.

Not following on adding +10% accounting for oil loss, which is very little. I personally see a -1% loss using a capsule filter. How does adding +10% of raws do anything for lost oil? You just have less oil that is still not meeting label claim.

Got it. Still new to brewing so just trying to learn and throw ideas out.

 

[Anonymous member 154437]

Got it. Still new to brewing so just trying to learn and throw ideas out.

Use the steroid homebrew calculator and when you know your raw purity adjust for 100% and you will hit your target every time

 

[Sampei]

Use the steroid homebrew calculator and when you know your raw purity adjust for 100% and you will hit your target every time

I change the purity 2% lower than the real one to account for slight human errors while brewing. Always hit the target that way perfectly. Nowadays I'm trying perfect purity and 5℅ overdose on small concentration

 

[Photon]

Isn’t there always a variance with all jano tests? I would rather have it over than under. And for those that don’t test their actual raws, but go off of what someone else tested it as. Think a 10% overdose wouldn’t hurt. And you also account for any kind of loss that could happen with oils getting stuck in the filter or in any beaker/graduated cylinders you may use.

For most oils its usually between 2 to 3 percent variance. Might be a little higher for BU.

 

[MrTexas2]

2800$ for 100g of primo pre-order lmao

What?

 

[B Ware]

I change the purity 2% lower than the real one to account for slight human errors while brewing. Always hit the target that way perfectly. Nowadays I'm trying perfect purity and 5℅ overdose on small concentration

This is actually smart. I really like the idea of adding +5% for smaller concentrations of 100mg/ml products.

 

[B Ware]

What?

Apparently it gets significantly cheaper the more you buy as I was quoted $20k per kg. Still more than double what it was before the China shit show.

 

[Photon]

Apparently it gets significantly cheaper the more you buy as I was quoted $20k per kg. Still more than double what it was before the China shit show.

Issue is the unknown purity
One US Dom vendor posted a Jano test of 80% TRA this week lol.

 

[newguy2]

Issue is the unknown purity
One US Dom vendor posted a Jano test of 80% TRA this week lol.

Yeah that would be rough to pay that much and get some stuff that tests so crappy. Glad I am not in the raw market.

 

[Sampei]

This is actually smart. I really like the idea of adding +5% for smaller concentrations of 100mg/ml products.

Yeah on higher concentration it skews the final target too much but for a 100mg or even 200mg its 5/10mg max overdose if one can measure things properly. So it's "perfect"

Except for lady Test in that case I do only adjustment for purity and that's It. If it comes slightly underdosed not a big deal its even better, worse case scenario the lady will have to inject slightly more but sure as hell she ain't growing a beard or a dick

 

[Diesel77]

Yeah on higher concentration it skews the final target too much but for a 100mg or even 200mg its 5/10mg max overdose if one can measure things properly. So it's "perfect"

Except for lady Test in that case I do only adjustment for purity and that's It. If it comes slightly underdosed not a big deal its even better, worse case scenario the lady will have to inject slightly more but sure as hell she ain't growing a beard or a dick

What dose do you make for the ladies . I'm going to brew some up for my wife. I was thinking 20 mg/mL.

 

[TallandSmall]

Yeah that would be rough to pay that much and get some stuff that tests so crappy. Glad I am not in the raw market.

Unfortunately, we’re all in the raws market one way or another.

 

[newguy2]

Unfortunately, we’re all in the raws market one way or another.

Yes you are right on that one.

 

[AlexDavis43]

What dose do you make for the ladies . I'm going to brew some up for my wife. I was thinking 20 mg/mL.

I've seen Lady Test brewed anywhere from 10 to 50 mg/mL; seems like the lower the better, for more accurate dosing (eg, it's easier to measure 0.5 mL for injection than 0.1 mL)

 

[Sera]

I always thought subQ might be a good idea for women, since so little oil might be needed. It remains to be seen if that really works or not. Never tried subQ myself. 500mg/ml test D once per week subQ, 2 units on an insulin syringe per week. Is that insane or genius?

 

[TanFishMan]

I always thought subQ might be a good idea for women, since so little oil might be needed. It remains to be seen if that really works or not. Never tried subQ myself. 500mg/ml test D once per week subQ, 2 units on an insulin syringe per week. Is that insane or genius?

Subq has been fine for me. Just avoid areas that are seen cuz you will look lumpy

 

[pheno609]

Issue is the unknown purity
One US Dom vendor posted a Jano test of 80% TRA this week

You are sure it was a domestic vendor and not chinese? I was starting to think he got raws from anna