150mg/ml primo e recipe- how does this look?

[Slicknyc]

I used .95 for conversion so this is how my math looks for 40ml @ 150mg/ml

6g raw - 5.7ml
8ml bb 20%
.8ml ba 2%
25.5ml mct oil

Just gonna heat up the bb, mct and raw first to about 60-70% Celsius and stir for approx 15 min then let cool down to 50 degrees before adding ba and then filter after below 40.

 

[RackPuller]

Fuse it up just raw and bb and a little bit carrier first m8

you take that to raw melting point, then you take it down just a tiny hair then what you do is let that oversized tic tac spin in high at that current temp for 15-30min then you lower temp just another hair

then you add the rest of oil but not Ba yet, you let that now stir on high for another 10 min then you add the ba and turn that heat off , drink meal 3, then you filter those hormones

 

[Eman]

That looks fine but, just do you know, you can go to to 200mg/ml with the same % of solvent and it will hold easily.

 

[Slicknyc]

Thanks guys yeah I just did a batch at 200mg/ml and I messed it up - somehow the .2 whatman started backing up with oil but it was heavy consistency like a gel. I used a vial adapter thinking it might be easier but in the process I neglected to vent so I think the pressure from vial caused some issues with the filter. Don’t like the gel stuff though so I’m just gonna try again at lower concentration and vent the vial and see how that goes. You guys have any idea why the filter overflow was like a gel? Thanks for feedback guys.