MESO-Rx Sponsor AASraw: GMP-Certified Steroid and Peptide API Manufacturer

what temperature should i get this up too you think? i’m not a new brewer but honestly i never have to use much heat at all for anything.
180F to get it going and then once close can back off to 140F, keep in mind just because you turn it down don't mean it's not still 180F, it just allows it to start cooling down as you add WARM oil, oil at 140F.

I keep it at 120F to 130F during the filtration process.

Cold Test C, won't fully dissolve nor filter worth the crap.
 
To be honest, you shouldn't need much heat at all.
Unfortunately, your case looks different lol

Do you have a smaller beaker?
100ml?
Get it hot, maybe 70c
See if it clears up
Then filter it

If it filters, then the issue is that it wasn't dissolving at all

Heating large beakers isn't easy, unless u use a beaker warmer
View attachment 376124
70C which is 158F should do it at this point, 180F is when it's still powder, his is dissolved or partially.
 
To be honest, you shouldn't need much heat at all.
Unfortunately, your case looks different lol

Do you have a smaller beaker?
100ml?
Get it hot, maybe 70c
See if it clears up
Then filter it

If it filters, then the issue is that it wasn't dissolving at all

Heating large beakers isn't easy, unless u use a beaker warmer
View attachment 376124
Umm, I disagree with the beaker warmer, just get it going up to 180F, than back it off in time.

Beaker does look comfy though lol.
 
He has 2L of oil lol
Getting the heat evenly distributed is going to take some time
Heat the oil while the test c is cooling down to 140F, add the heated oil, oil heated at 140F, than homogenize, that simple.

2000ml, 5000ml, doesn't matter. It has to be all warm and stay warm to filter.
 
Back
Top