Adding raws to already finished oil???

[Ejetson]

Yo! I have a question for the brewers here. I’m thinking it’s not a very good question bc I have looked all over the web and found no answer. So here it is... if I have already finished tren ace 100mg/ml could I add mast p raws to it to make a cut blend? It’s brewed at 2/15 in gso and it has No pip. If this could be done what would I have to increase the bb to? I’d like to see the mast a bit higher than the tren. Hopefully 100tren a /150 mast p. Thanks

 

[AnTabolic73]

I'm sure it's possible, but would it worth it? I would just brew the mast on it's own. And just pin them both.

If the tren is already in vials, I would definitely just keep them separate.

 

[Iron Frenchie]

Yes you could do that. 100 Tren a and 150 mast is not going to be easily held. You will def need 25%~ BB but I would just use EO and give it a shot. 10% EO to start.

At the end of the day you should just make some mast p on its own.

 

[Ejetson]

Yea that’s consensus on what I’ve been reading when it comes to blends. Most say to just blend separate and pin more oil. My goal was to pin less oil Ed. I was wanting to have the tren/mast blend separate from the test p so I could run the test higher or lower as needed. But I definitely wanted the mast to be run high.

 

[RCCP]

You coulds but remember you’ll need to filter again.

 

[Iron Vett]

You also have to take into consideration that you will be lowering the concentration of the finished tren a. As you add the mast, you will be increasing the total volume by the displacement of the mast raws thus lowering the mg/ml concentration of the tren

Edit: @Ejetson

 

[Ejetson]

So let’s say I did go add mast at 125mg/ml, how much do you think it would lower the tren?

 

[Holidaypay]

So let’s say I did go add mast at 125mg/ml, how much do you think it would lower the tren?

It would make things alot more complicated than it needs to be u would have to know the % of everything before an figure out what u need to add it will drop the tren % significantly u will have to filter an bottle everything again imo just make the mast an add it to the pin with tren

 

[Holidaypay]

It would make things alot more complicated than it needs to be u would have to know the % of everything before an figure out what u need to add it will drop the tren % significantly u will have to filter an bottle everything again imo just make the mast an add it to the pin with tren

I'm all for injecting less oil If you have more tren raws than a blend would be a good idea for your needs just with the tren pre made an bottled its going to be a hassle

 

[master.on]

Yo! I have a question for the brewers here. I’m thinking it’s not a very good question bc I have looked all over the web and found no answer. So here it is... if I have already finished tren ace 100mg/ml could I add mast p raws to it to make a cut blend? It’s brewed at 2/15 in gso and it has No pip. If this could be done what would I have to increase the bb to? I’d like to see the mast a bit higher than the tren. Hopefully 100tren a /150 mast p. Thanks

Sure you can
the worst that might happen is that you exceed its solubility and some raws precipitate, so you may need to add extra oil and maybe BB to make it dissolve.

Don't forget to sterile filter it again.