Adding water to test......??

[GotBench??]

I was told by a fellow gym "Buddy" that If I added a bit of sterile water to my test injections it could help ease the pain a bit. SO i added about 1/2 a cc of water to my 10ml vial of qv enanthate. Well.......the test turned cloudy and is not as clear nor does it have the same yellowish look to it.


Is my vial of test still good to use or did I ruin it. I had never done this before and i was hesitiant but "Buddy" is quite knowledgible (spelling??) on this subject so i beleived him.

any input good or bad would appreciated

thanks

 

[goldlifter]

you would have been MUCH better off cutting it with sterile oil and filtering it. what i would do is bake it in the oven with a needle inserted(with the plastic top clipped off) until the water evaporates.

 

[01dragonslayer]

you would have been MUCH better off cutting it with sterile oil and filtering it. what i would do is bake it in the oven with a needle inserted(with the plastic top clipped off) until the water evaporates.

I agree. Cutting it with some sterile oil or B12 will help with the pain. Also try to inject very slowly and massage the site post injection.

 

[Neodavid]

Water and oil shouldn't mix, you should get the 'lava lamp' effect i would think.

I was told by a fellow gym "Buddy" that If I added a bit of sterile water to my test injections it could help ease the pain a bit. SO i added about 1/2 a cc of water to my 10ml vial of qv enanthate. Well.......the test turned cloudy and is not as clear nor does it have the same yellowish look to it.


Is my vial of test still good to use or did I ruin it. I had never done this before and i was hesitiant but "Buddy" is quite knowledgible (spelling??) on this subject so i beleived him.

any input good or bad would appreciated

thanks