AI on second blast

accidentaljedi173

Well-known Member
I'm planning my second blast of 500mg test and 500mg mast. I will more than likely be titrating to these doses.

My only question is, being I've done 500mg test only before and I needed an ai. Would I be wrong to just go straight to starting the ai I needed or wait for the blood work?
 
Well, you've also said you have done 250 test 250 mast, how was your e2 then? If you get the suppresion from mast then there's no need to take an AI. if on 250-250 you had a e2 of 70+ then you most probably need an AI too.
 
Well, you've also said you have done 250 test 250 mast, how was your e2 then? If you get the suppresion from mast then there's no need to take an AI. if on 250-250 you had a e2 of 70+ then you most probably need an AI too.
I didn't need an AI with 250-250. My e2 on just 500 test was pretty high like 150's. I'm just assuming I'll need one even with the masteron.
 
I didn't need an AI with 250-250. My e2 on just 500 test was pretty high like 150's. I'm just assuming I'll need one even with the masteron.

Do you know where your e2 was on 250-250? You didn't need could mean you have a 30 e2 or a 100 e2. I didn't have any high e2 symptoms at 106pg/ml.. So just make a decision and keep it until you have bloodwork, if you decide to not take AI don't take any until test it and if you decide to take start with a protocol and stay consintend until you reach and pin for a month 500-500 and then test e2.
 
I need assistance with this also. New to AI, would 0.5mg of Adex E3D or EOD be enough for 500-600mg of test?
 
I need assistance with this also. New to AI, would 0.5mg of Adex E3D or EOD be enough for 500-600mg of test?
That would depend on your bloods. I'm familiar with my response, and want to know if I should start ai immediately when I begin my blast. But for reference e3d was good for me at 500mg.
 
Back
Top