MESO-Rx
Anabolic Steroids
Another cloudy tren thread
- Thread starter Evom1
- Start date
You ruined Christmas =(
Haha thanks man, hopefully the cure has been discovered
Did you not see the post I tagged you in before.
I just did! Sorry
All good. I think you’re in the clear with your brew. If @ickyrica sent you finished Tren E then just add the amount you need to yours and reheat. Swirl it while it warms back up and once it’s all clear you should be good to go. If it’s raws you’re going to have to filter again.
Finished @ 200mg/ml
Holidaypay
Member
Ace finished an I'm gna get e to fix it sometime in the near future I was actually gna grab some e already so I don't have to pin ed it worked out good
The e would be raws I never buy finished
@Holidaypay yeah so In that case add the raws to the cloudy solution and reheat and filter again because you’re adding the raws. The loss in compound should be relative to the loss in oil making less total volume but should still be the same mgml ratio.
So this was 200mg finished e to 10ml finished a?
Yeah the volume would have been to hard to figure out how to add it so I did 1ml Tren E to 10ml tren A. Based on pandas math I think you should add 1.25 Tren E to your tren a. That’s where I would start but I think if you had to add a little more that would be fine.
Rigger622
Member
I did a batch of tren A in Feb.2018 from PPl. Grinded up the raws in a mortar and pestle. Added to beaker and added the ba and bb, kicked in the magnetic stirrer, no heat for about 5min. Added MCT oil slowly with a 60ml syringe I use for measuring added a little heat to warm it up and let it go for 30min. Year later and still looks top notch, started using whats left last week no pip at 100mg + 10%. This was just my experience.
Last edited:
Most of the tren issues started showing up summer and more recently.
Update.
No luck so far. Added 1ml of tren e and added a small amount of heat, stirred for a while, let it cool over night, still cloudy... Added a second ml and tried again, then a 3rd ml Now I have a mixture of half clear half cloudy stuff on the bottom half after sitting 24hrs
No luck so far. Added 1ml of tren e and added a small amount of heat, stirred for a while, let it cool over night, still cloudy... Added a second ml and tried again, then a 3rd ml Now I have a mixture of half clear half cloudy stuff on the bottom half after sitting 24hrs
If you shake it will the stuff on the bottom come up and mix itself again. If so I’d shake it all up add another ml and reheat.
Hmmmm, maybe a little stronger heat?
It's in a beaker, so I'm stirring it. If I shake it my girlfriend is going to be pretty angry lol
I'll bump up the heat @ickyrica
Alright guys so I tried using more heat tonight and I now have a clear mixture. I'll update in 24hrs.
It did darken up a bit but I Dont think it's an issue. I don't have a digital thermometer so I set a second beaker with a small amount of water in It next to it on the hotplate with the logic of if that water doesn't boil, it's not reaching 212* which means the tren is under that as well.
It did darken up a bit but I Dont think it's an issue. I don't have a digital thermometer so I set a second beaker with a small amount of water in It next to it on the hotplate with the logic of if that water doesn't boil, it's not reaching 212* which means the tren is under that as well.
You smart fucker lol
