Bottle top filter problems

[ForeverSmall]

I've used the bottle top filters before with no issues but this batch if test is giving me some issues.

200mls of 250mg/ml test E in MCT and I cant get the shit to filter.

Never had this much trouble before. I've cracked two only as 5psi and the other two blew out the filter after like 5hours. The edge like slips off and just blows out the seal. Luckily I caught it at the end pissing through because I would have assumed it filtered properly. Now the oil looks slightly cloudy but I'm not sure.

I need to order more filters now. Should I ditch this batch? Run it thru a .4 filter then a .22?

 

[limitphobic]

whats the membrane of the filters youre using?
and
whats the mixture of BA/BB etc for the test?

 

[skinnyman]

It al depends on what filter membrane you've used like limitphobic asked. Lately people have had issues with filtering test e. If it looks cloudy something then some solvent you're using is dissolving your filtermembrane or the actual plastic flask or you've gotten some moisture in there. Are you using ethyl oleate?

Don't filter twice, once is enough. Doesn't matter if its .45 or .22

 

[ForeverSmall]

I threw that entire batch away. Got new raws and no more problems. Thanks for the tips though.

 

[skinnyman]

I threw that entire batch away. Got new raws and no more problems. Thanks for the tips though.

You could have tried to just re-filter it It really sucks when this happens.

 

[Carolina Spanky]

I occasionally have this problem with test e as well. Also have had it with sust before. Can get 4-500 with one batch and 200-250 that takes FOREVER with the next batch. Same exact recipe and bottle top every time. Has to be the raws.

 

[Ridethelightningbarefoot]

Im really getting more and more weary of raws..

 

[2019SIERRA.AT4]

I occasionally have this problem with test e as well. Also have had it with sust before. Can get 4-500 with one batch and 200-250 that takes FOREVER with the next batch. Same exact recipe and bottle top every time. Has to be the raws.

Im really getting more and more weary of raws..

Yes sounds like the raws were a little less than pure. Yeah it could have been moisture in the oil or the filter membrane or a cheap bottle top that dissolved. But if I only got one guess it would be the way the raws were processed. The raws manufacturers are always looking for new ways to produce raws faster and more cost effective. Sometimes at expense of quality.

If my raws ever acted unusual I would send them in for testing. Even 96% pure raws could have anything in them making up the remaining 4%. Raws suppliers need to be held accountable. People are injecting this stuff. It was best you threw those raws out. Don’t ever inject anything that’s acting volatile or contaminated in any way unless you are given a sure answer by your raws supplier what the cause is and if the problem can be ironed