What is the best way to melt these crystals that are stuck to the side of my vials. It's Tren E
MESO-Rx
Anabolic Steroids
Crystals in Gear
- Thread starter micro
- Start date
Well I but a cup a water in the microwave and heated it up and put the vial in the cup and the crystals are melting. Just have to see if it will stay that way.
DangerousG
New Member
micro said:
More than likely unless you add a solvent they will reform when cooled.
I use same method as you but it takes sometimes a few times to break crystals down.
gman67
New Member
I simply put the vial on a skillet and heat a little until dissolved or just heat some water and place the vial in,,you may want to add a little ba if you've got some but I've never had to if it wasn't too bad to begin with.
DangerousG
New Member
thats works well to long as you don't melt rubber stopper.gman67 said:
I had some homebrewed prop crash on me a few times.
Last edited:
gman67
New Member
DangerousG said:
Never had a problem melting the stopper,,it's not necessary to heat it that much,,I actually had some homebrew cyp turn completely solid,,put it in some warm water and added a little ba and kept on trucking.
Thanks for all the help. I just heat up some water and but the vial in it and that melted it all. So when I get home from work I'll see if it crashes again.
Micro
Micro
PumpPumpItUp
New Member
Blow dryer for sure the best promise....
PumpPumpItUp said:
I used a blow dryer on some PL Cyp I had but that was a different situation. The crystals seem alot harder and would take more heat to melt them. The cyp just got cloudy and thick and the blowdryer worked great for that.
DangerousG
New Member
The prop crystallized very hard had to boil water and "bathe" in water about 30 to 40 mins until it broke down and suspended again.
Ain't no way a hair drier would have worked on mine some powders that crystallize melt at much lower temp such as enth or deca.
Ain't no way a hair drier would have worked on mine some powders that crystallize melt at much lower temp such as enth or deca.
The Crystals in my TrenE melted in about 10mins in the water that I heated up in the microwave.
graybass
New Member
Had same thing with Tren E. Heated water to low boil, than removed from heat and dropped the vial in. (water was only about 1 1/2 inches deep)
Waited about 2 mins. swirled vial gently, put back in water for another 2 mins.
After that it was just good looking oil!
If you notice any crystals in the weeks to follow, just repeat when needed.
Quality was fine.
JMHO on what to do.
GB
Waited about 2 mins. swirled vial gently, put back in water for another 2 mins.
After that it was just good looking oil!
If you notice any crystals in the weeks to follow, just repeat when needed.
Quality was fine.
JMHO on what to do.
GB
graybass said:Had same thing with Tren E. Heated water to low boil, than removed from heat and dropped the vial in. (water was only about 1 1/2 inches deep)
Waited about 2 mins. swirled vial gently, put back in water for another 2 mins.
After that it was just good looking oil!
If you notice any crystals in the weeks to follow, just repeat when needed.
Quality was fine.
JMHO on what to do.
GB
Same thing I did, and it was the same Tren E you had.
