Deca Raw arrived as a brick

Hey guys, need some help here.
My deca raw arrived looking like a brick. I tried breaking it into smaller pieces and dissolving it but the solution is cloudy both in a beaker and after filtering.
All other raws 20240418_154824.jpgScreenshot_20240418_154711_Gallery.jpg20240418_151556.jpg
 
i use a razor blade and cut slivers at a time and weigh it out on my analytical scale in pieces until i reach desired mass. once i reach it i take the razor and dice it into the smallest pieces possible as though you're breaking up a rock of that white party fun substance. and all that condensed steam on the edges of your beaker seems to be water in your mix. prob from the brick of hydrophobic AAS powder. it will boil off at a much lower temp then anything in your oil solution
 
Thank you so much guys. Boiling the solution won't damage my nandrolone?
you prob wont get it to boil. MCT boils at 512F, Water boils at 212F, youll prob have the water content steam off without seeing any boiling action. you might see little bubbles as well if theres enough water in it. just keep your heat over 220F and below 250F and keep the mag spinning until you stop seeing any bubbles or steam condense on the beaker. or simply run it until you see the cloudiness go away if that happens before you see the bubbles or steam stop
 
i use a razor blade and cut slivers at a time and weigh it out on my analytical scale in pieces until i reach desired mass. once i reach it i take the razor and dice it into the smallest pieces possible as though you're breaking up a rock of that white party fun substance. and all that condensed steam on the edges of your beaker seems to be water in your mix. prob from the brick of hydrophobic AAS powder. it will boil off at a much lower temp then anything in your oil solution
Am the the minority here? I've apparently never cut up a massive crack rock
 

Sponsors

Back
Top