Deca/test C blend

[Cashton]

Hey guys, I haven’t been very active recently, got a lot of stuff going on in life right now (good stuff) so I’ve taken time away from the forum, I come and read once in a while and reply here and there so I’m not gone completely, just have other things that my focus is on right now.

I’ve got a bunch of test E, C and nand deca and I’m wondering if there’s any reason I couldn’t, or shouldn’t be able to make a test c/ deca blend, anyone with experience with this posting some words of wisdom is greatly appreciated always.

 

[theotherguy]

Just curious, are you wanting to make this particular blend because it’s what you have on hand or did you buy these compounds knowing you would blend them?

 

[Cashton]

I bought the E about 9 months ago, the deca and the C probably about 5 months ago, and was going to do another deca/test run.

 

[theotherguy]

I have never made this blend, but I would imagine, you could do 150/100 deca/test c without issue. MAYBE 150/150, but I am not sure if the test c would hold that high without a little extra solvent

 

[Cashton]

I have never made this blend, but I would imagine, you could do 150/100 deca/test c without issue. MAYBE 150/150, but I am not sure if the test c would hold that high without a little extra solvent

I have test E as well but I was under the impression it’s easier to keep the test c is solution, I was hoping for a 200/200 mix but I might just have to experiment a little bit.

 

[theotherguy]

I have test E as well but I was under the impression it’s easier to keep the test c is solution, I was hoping for a 200/200 mix but I might just have to experiment a little bit.

When I want to experiment with higher doses. I brew it up and let it sit for 24-48 hours. If it doesn’t crash, I’ll filter it. If it does, I’ll add some BB (I try not to go over 25%, although I’ve used 30% with no issue), reheat, remix, and wait another 24-48 hours.

Sometimes I’ll play around with adding more heat or longer heated duration, but haven’t found that to make much of a difference, personally.

If it still crashes (depending on how much BB I have already used) I’ll dilute with carrier oil to lower the concentration and start the process again.

 

[H&M]

Test C with deca is ok maybe 150/200 or max 200/200 with the standard 2/20
-I have NO real life experience with this combo!Never brewed this combo,but I think TECHNICALLY it can go

Test Ena with deca-very easy to brew,did it many many times,200/200 is easy with the standard 2/20,maybe 2/15 is enough

 

[Cashton]

Test C with deca is ok maybe 150/200 or max 200/200 with the standard 2/20
-I have NO real life experience with this combo!Never brewed this combo,but I think TECHNICALLY it can go

Test Ena with deca-very easy to brew,did it many many times,200/200 is easy with the standard 2/20,maybe 2/15 is enough

Thanks to all that have given input, a great member of this board and good friend reached out with a recipe and some words. Oh

 

[Samwantstobrew]

Going to give

Deca 200/ test e 200 blend a go

 

[Deleted member 127229]

If your test isn’t higher than your deca you will likely get deca dick. I have at least.