First brew results, test cyp 300, mast, tren next

[kain]

I brewed my first small batch (50mL) of test cyp last month using a magnetic stirrer hot plate:

300mg/mL
1/20 BA/BB

I filtered it with a 22 Whatman syringe filter into a couple sterile vials.

All three vials were not crashed for weeks in my basement at ~61 degrees F. I extracted 1.5mL to send to Jano for testing and that vial crashed the same day, as well as the oil I put into the 2mL vial. The other two vials remain fine. I wonder if it was it air I added to vial to draw it up? See image.

Jano testing came back good on dosage but it’s clear I need to increase BB or BA. I’ll increase BB to 30 and see how it holds after following the same process.

https://janoshik.com/tests/40929-Sample_4_CA86VY6A5DFR

I’m going to do mast and tren next.

 

[narta]

Test c at 300mg is a bit high to hold. You will probably need to reheat it before administration.

If you want to brew high concentration Test opt for Test D next time it can hold up to 400mg/ml with 40% bb

 

[kain]

Test c at 300mg is a bit high to hold. You will probably need to reheat it before administration.

If you want to brew high concentration Test opt for Test D next time it can hold up to 400mg/ml with 40% bb

I don’t have any experience with Test D. I’ll look into it, thanks!

 

[AlexDavis43]

I brewed my first small batch (50mL) of test cyp last month using a magnetic stirrer hot plate:

300mg/mL
1/20 BA/BB

I filtered it with a 22 Whatman syringe filter into a couple sterile vials.

All three vials were not crashed for weeks in my basement at ~61 degrees F. I extracted 1.5mL to send to Jano for testing and that vial crashed the same day, as well as the oil I put into the 2mL vial. The other two vials remain fine. I wonder if it was it air I added to vial to draw it up? See image.

Jano testing came back good on dosage but it’s clear I need to increase BB or BA. I’ll increase BB to 30 and see how it holds after following the same process.

https://janoshik.com/tests/40929-Sample_4_CA86VY6A5DFR

I’m going to do mast and tren next.

View attachment 281095View attachment 281096

Great work for first batch (or any batch).