System7
Well-known Member
I hear you. It was the plan. Got loaned out or something. I'll use it next go round.
MESO-Rx
Anabolic Steroids
First Ever Brew - Mast P
- Thread starter Leancuisine
- Start date
Holistic
Member
Yeah, i get out of the shower and lots of hairs all over my shoulders... i dropped the mast dosage in half... I started some tren and hair everywhere so i dropped the tren for now until i bring mast dose down. I'm 41 so I've been receeding ect.. but last 2 weeks was just a bit too much hair..
Cyp will hold at 250 mg/ml in gso with 1%,20% no eo needed. I know .45 is faster but I would definetly go with .22 filters. I would also ditch the syringe filters and either buy a buchner filter (as long as you can properly sterilize it) or fox autofil filters. You can get a 2.5cfm vacuum pump on ebay for $50 or at harbor freight with online coupon for $77
Leancuisine
New Member
I put it at around 350mg/ml. And I was looking into the foxx auto fill, but really it's not hard using a syringe filter. Especially at the low amounts I'm brewing.
Holistic
Member
Just a thought on bottle tops.... prefilter is a 1.00 on med lab supply and helped a lot to keep the .22 filter working smoothly. Last brew I started with 100ml of test e and then same filter switched to 100 ml of NPP (thinking some test will end up in the NPP but thats fine) and then 250ml of tren (same filter thinking - filtering tren last... theres no tren in the NPP or test e)... you will love bottletops... so easy and fast, but a prefilter will help a lot...
Holistic
Member
No worries of the vacuum pump having a guage or adjustible pressure as far as rupturing the filter? Also, did it smell bad running it inside?
The oil that comes with the vacuum pump is junk throw it out and get some good oil for it and the o ring on my filling cap was to big so I had to change it out otherwise it would smoke alittle. On the vacuum pump i had put a fitting for the autofil on each side and it fits loosely in the pump but tight enough to still create a strong vacuum then I dod away with that and installed a tee with a valve in the line as well as a gauge past the tee close to the filering unit so that I can crack the valve open to adjust the pressure. Now I use a buchner filter (big savings over bottle top filters)
Leancuisine
New Member
Damn those things are cheap.... what kind of filter does it use?
Buchner funnels use filter disks. There are alot of different manufactures of them and alot of different sizes as well. I do not trust the chinese filters so I spend alittle more money and buy the whatman or millapore filter disks. Filter disks are measured by 1-6 I believe just make sure you get the .2um filters and that you properly sterilize everything before using. There is a thread vacuum filtering problem here where I posted a video where you can see how it works.
Holistic
Member
Can you recommend a good buchner filter setup? What site? Great idea concerning the T and valve/gauge setup...
PIZZABOY
New Member
This hombrew bug has itching to try. I had some test c from a source that my body did not like, i wonder wich ingredient was causing the allergic like reaction. I like the idea of controling what goes in it, i knew i had a blast cooking FINA in the past. Time to pull the trigger
Check out this youtube video it shows you how to set up the filter as well as the best type to buy. If you buy a cheap chinese one (like I did) I would theow away the filters it comes with and buy some whatman or milapore .22um filter disks
Holistic
Member
Irony is cheap chinese stuff is where a lot of expensive domestic stuff starts out.... can u recommend a source...
Ebay or amazon.
