Fix npp ?

[Detroitmonster]

Ok so my npp is extremely painful.
I home brewed it at 200mg per ml 50 ml
I used 10 grams npp
23% bb 11.5 ml
2% ba 1 ml
29 ml gso
What should I do ?
Would it fix it if I add
9 ml bb
1ml ba
35.75 gso
Would this make it 100mg per ml if I add this to it ? And then just eat and filter it ?

 

[Sssxc]

Ok so my npp is extremely painful.
I home brewed it at 200mg per ml 50 ml
I used 10 grams npp
23% bb 11.5 ml
2% ba 1 ml
29 ml gso
What should I do ?
Would it fix it if I add
9 ml bb
1ml ba
35.75 gso
Would this make it 100mg per ml if I add this to it ? And then just eat and filter it ?

I have made 175mg with no pip whatsoever using standard 18% BB and 2% BA.

 

[Detroitmonster]

Thanks sssxc . How would I go about criticing my original recipe to make it into the 175mg recipe? Any help would be awesome

 

[Detroitmonster]

Could you help me out on the recipe. I’m a bit confused on the math and percentage part

 

[Meterman05]

Could you help me out on the recipe. I’m a bit confused on the math and percentage part

If you want to keep your original recipe you would need to add another 11.5 mL BB, 1 mL BA and 33.25 mL GSO. That should give you 100mL of100mg/mL of NPP at a 23% BB and 2% BA mix. Then you can reheat and filter again.

Strange that you have a ton of PIP though. I have made 200mg/mL NPP without much PIP using 25%BB and 2% BA with mig840.

 

[Boss hog]

Ive only gone to 150 and I never had any issues. If it was me, I would just add a little sterile oil to each shot to cut it down a bit.

 

[Detroitmonster]

I will try to reach filter and then goes and see if I have the same problem

 

[Detroitmonster]

I think it could be the Raws

 

[Detroitmonster]

I didn’t mean to say I think it could be the raws . I meant to ask could it be the rosI meant to ask could it be the raws

 

[Ridethelightningbarefoot]

For me I brew with as low of solvents and ba as possible. I made test c and npp at 100/100 with 13bb and .08 ba, it's good! Currently running 900/900. When I have had pip in the past I usually just take the hit and dilute a little bit- reheat refilter. I have also just added sterile oil to the syringe before pinning which works well too

 

[Ridethelightningbarefoot]

For me I brew with as low of solvents and ba as possible. I made test c and npp at 100/100 with 13bb and .08 ba, it's good! Currently running 900/900. When I have had pip in the past I usually just take the hit and dilute a little bit- reheat refilter. I have also just added sterile oil to the syringe before pinning which works well too

Wow big mistake .8%ba haha sorry

 

[sierrak1lo]

You should not need to add more BB if you want to dilute. If it’s holding in solution at 200 mg/ml then there is enough solvent for it to hold at 100 mg/ml. Just add oil.