Started hcg last night, surprised at how little I had to measure into each syringe. It was kind of hard to get exact amounts. For 250iu, it's 20 syringes at only the very first mark on a 1cc syringe. Barely visible. (my amps are pregnyl, 5000 iu).
I was wondering if this would work, adding again as much anti-bacterial water, to make it easier to load and measure.
Should have gotten longer pins... (have half inch).
Everything went fine until after I mixed the solution, then turning the amp upsidedown made me lose maybe 1/4rth of the hcg (another site had guys saying to turn it upsidedown, which worked so well for the solvent, I figured the solution would be the same way... but apparently the solvent alone is more viscous or something).
If I add as much water, it'l be a lot easier to draw, and easier to measure. Anyone else do this, or do I just need to hone my skills.
I was wondering if this would work, adding again as much anti-bacterial water, to make it easier to load and measure.
Should have gotten longer pins... (have half inch).
Everything went fine until after I mixed the solution, then turning the amp upsidedown made me lose maybe 1/4rth of the hcg (another site had guys saying to turn it upsidedown, which worked so well for the solvent, I figured the solution would be the same way... but apparently the solvent alone is more viscous or something).
If I add as much water, it'l be a lot easier to draw, and easier to measure. Anyone else do this, or do I just need to hone my skills.
