guyfawkes1010
Member
Ok so I'm setting up a small home lab/clean area.
My equipment is as follows:
Room is filtered by a HEPA and charcoal panel.
Ac duct will be routed through an ac infinity air box with merv/fpr 10 filter. Output pointed towards HEPA filter unit.
Workbench will have a horizontal laminar flow hood filtered with a HEPA filter.
I'm not filling or cleaning open vials. Presealed/sterilized vials only.
Only reason I'm going this far is because of the need to vent the vials while heating and/or filling.
Any ideas, comments, or suggestions?
My equipment is as follows:
Room is filtered by a HEPA and charcoal panel.
Ac duct will be routed through an ac infinity air box with merv/fpr 10 filter. Output pointed towards HEPA filter unit.
Workbench will have a horizontal laminar flow hood filtered with a HEPA filter.
I'm not filling or cleaning open vials. Presealed/sterilized vials only.
Only reason I'm going this far is because of the need to vent the vials while heating and/or filling.
Any ideas, comments, or suggestions?
