MESO-Rx
Anabolic Steroids
ingredients
- Thread starter big gunns
- Start date
Beefster
New Member
You can get everything you need (filter, bb, ba, open and sterile vials, syringes, etc.) minus the powder, from getpinz.com as well as many other sites.
cinnabar8521
New Member
Test Enanthate 10 gram conversion
Needed
10 grams test E
Benzyl Alcahol 2ml 5% BA
30.5 ml sesame oil
Syringes 3cc & 5/10cc
18 or 20 guage needles
Vial
Sterile Vial
Whatman sterile filter
1. Weigh out 10 grams of powder.
2. Place powder in vial.
3. Add BA to the vial.
4. Heat oil in the oven to help sterilize it, heat to at least 212 degrees F. I usually heat my oil at 275 to be sure, I put the oil in a muffin pan, just fill one of the indentions this is plenty for these experiments. Also heat more oil than you need, as you will not be able to get it all out of the pan.
5. Add oil to the vial, save 2 ml of oil in the syringe for later. Gently shake vial.
6. Heat mixture if necessary. I like heating my powder products, by placing the vial in a frying pan, and placing it on the eye of the stove.
7. Place a 18 or 20 gauge needle in the sterile vial attach whatman sterile filter.
8. Place another needle in the sterile vial to relieve the pressure.
9. Draw out solution with a syringe, run though whatman filter.
10. Take other syringe with 2ml oil, run through whatman into solution.
Makes 40ml @ 250mg/ml
Test Prop for 10 grams
10 grams powder
72.5 ml sesame oil
5ml Benzyl AlcoholA 5%
15ml Benzyl Benzoate 15%
Syringes
Vial
Sterile Vial
Whatman sterile filter
1. Weigh out 10 grams of powder.
2. Place powder in vial.
3. Add BA & BB to the vial.
4. Heat oil in the oven to help sterilize it, heat to at least 212 degrees F. I usually heat my oil at 275 to be sure, I put the oil in a muffin pan, just fill one of the indentions this is plenty for these experiments. Also heat more oil than you need, as you will not be able to get it all out of the pan.
5. Add oil to the vial, save 2 ml of oil in the syringe for later. Gently shake vial.
6. Heat mixture if necessary. I like heating my powder products, by placing the vial in a frying pan, and placing it on the eye of the stove.
7. Place a 18 or 20 gauge needle in the sterile vial attach whatman sterile filter.
8. Place another needle in the sterile vial to relieve the pressure.
9. Draw out solution with a syringe, run though whatman filter.
10. Take other syringe with 2ml oil, run through whatman into solution.
Makes 100 ml @ 100mg/ml
Needed
10 grams test E
Benzyl Alcahol 2ml 5% BA
30.5 ml sesame oil
Syringes 3cc & 5/10cc
18 or 20 guage needles
Vial
Sterile Vial
Whatman sterile filter
1. Weigh out 10 grams of powder.
2. Place powder in vial.
3. Add BA to the vial.
4. Heat oil in the oven to help sterilize it, heat to at least 212 degrees F. I usually heat my oil at 275 to be sure, I put the oil in a muffin pan, just fill one of the indentions this is plenty for these experiments. Also heat more oil than you need, as you will not be able to get it all out of the pan.
5. Add oil to the vial, save 2 ml of oil in the syringe for later. Gently shake vial.
6. Heat mixture if necessary. I like heating my powder products, by placing the vial in a frying pan, and placing it on the eye of the stove.
7. Place a 18 or 20 gauge needle in the sterile vial attach whatman sterile filter.
8. Place another needle in the sterile vial to relieve the pressure.
9. Draw out solution with a syringe, run though whatman filter.
10. Take other syringe with 2ml oil, run through whatman into solution.
Makes 40ml @ 250mg/ml
Test Prop for 10 grams
10 grams powder
72.5 ml sesame oil
5ml Benzyl AlcoholA 5%
15ml Benzyl Benzoate 15%
Syringes
Vial
Sterile Vial
Whatman sterile filter
1. Weigh out 10 grams of powder.
2. Place powder in vial.
3. Add BA & BB to the vial.
4. Heat oil in the oven to help sterilize it, heat to at least 212 degrees F. I usually heat my oil at 275 to be sure, I put the oil in a muffin pan, just fill one of the indentions this is plenty for these experiments. Also heat more oil than you need, as you will not be able to get it all out of the pan.
5. Add oil to the vial, save 2 ml of oil in the syringe for later. Gently shake vial.
6. Heat mixture if necessary. I like heating my powder products, by placing the vial in a frying pan, and placing it on the eye of the stove.
7. Place a 18 or 20 gauge needle in the sterile vial attach whatman sterile filter.
8. Place another needle in the sterile vial to relieve the pressure.
9. Draw out solution with a syringe, run though whatman filter.
10. Take other syringe with 2ml oil, run through whatman into solution.
Makes 100 ml @ 100mg/ml
ThePerpetrator
New Member
WOW Cinnabar!!!
You make that sound sooooo easy.
Wish I had the guts to try that on my own. I sucked at chem in HS though
You make that sound sooooo easy.
Wish I had the guts to try that on my own. I sucked at chem in HS though
cinnabar8521
New Member
ThePerpetrator said:WOW Cinnabar!!!
You make that sound sooooo easy.
Wish I had the guts to try that on my own. I sucked at chem in HS though
If you can make a batch of cookies, then you can make most gear, it really that easy.
