Injection Methods

[Alphamale23]

I have found that it is easier for me to pre-fill my syringes up with the oils a bunch at a time. For ex. I filled up 6 pins with Test E 1cc each and i am shooting twice a week. This way i just go to the box, grab the pin and boom in done. It also gives the oil time to settle with no bubbles.
Another part is I put rubbing alcohol in the needle cover and put it back on while i prepare the injection spot. This makes sure the needle is steralized.
The question is...is this a better/safer practice than filling up the needle before every injection?

 

[AGONIST]

I have heard of guy's doing this to their whole entire cycle. Sit down on like a sunday afternoon and load a hell of alot of syringes. I guess they feel that it is o.k as you are transfering from one sterile place to another. I wouldn't store it in there if I wasn't going to use it in that cycle........in other words, your good to go.

 

[tHe_ShOcKeR]

just so you know, rubbing alcohol doesn't really kill anything, it just wipes away the bad stuff without leaving anything behind, leaving a clean surface. so i don't know if soaking does a whole lot of good, but i guess it couldn't hurt. as for loading up all your syringes and stuff, it doesn't make a difference as far as sterility, safety, and such goes....it's just really fucking lazy.

 

[Alphamale23]

i really dont consider it being lazy. when i take the oil out before inject there is always bubbles. when i do it the other way the oil had time to completely settle.
i will admit that it is easier tho haha.

 

[GDSGFT]

i really dont consider it being lazy. when i take the oil out before inject there is always bubbles. when i do it the other way the oil had time to completely settle.
i will admit that it is easier tho haha.

Unless you're shooting like 6cc's of air, why should bubbles bother you?