Is filtering through a .45 whatman suppose to be quick right?

[trenpower]

I'm pretty sure it is but I just want to reaffirm as I'm ocd about doing everything right..

Filtered 50mls of warmed up tren with a .45 whatman attactched to a 18g needle with a 5cc syringe within 15-20mins, the drips were clear and constant and sometimes it would get a little foamy but I assume that's harmless and just the oil foaming from pushing too hard as I've never had a problem with that when injecting past brews.

 

[T_verde77]

.22 filter is preferred but ya the foam is normal when air is pressed through it

 

[XKawN]

Foamy, you probably have air in there. .45um filter should be rather quick. Other than that... not sure what your question is.

 

[trenpower]

Foamy, you probably have air in there. .45um filter should be rather quick. Other than that... not sure what your question is.

Just reaffirming is all, I always think about the guys who say it takes them hours to filter and when I filtered all I could think how easy it was I felt I must of done something wrong haha.

 

[T_verde77]

Just reaffirming is all, I always thinkg about the guys about who say it takes them hours to filter and when I filtered thinking how easy it was I felt I must of done something wrong haha.

No

 

[trenpower]

No

What do you mean?

 

[T_verde77]

U asked if having air is bad than deleted the message?

 

[Big_poppa_Bren]

The people who say it takes hours are the ones who use .22

However 45 will filter. But I don't trust them to fully sterilise the oil.

 

[T_verde77]

I've used .45 syringe filters before. filtering with .22 bottle top filtering is way faster.

if u need .45 syringe filters, I got a bunch I'm not going to use

 

[mercury]

0.22 um is harder to push but it will do a better job.

virus size range from about 20 to 400 nanometers

this one of the reasons why 0.22 is prefered

 

[Big_paul]

I'm pretty sure it is but I just want to reaffirm as I'm ocd about doing everything right..

Filtered 50mls of warmed up tren with a .45 whatman attactched to a 18g needle with a 5cc syringe within 15-20mins, the drips were clear and constant and sometimes it would get a little foamy but I assume that's harmless and just the oil foaming from pushing too hard as I've never had a problem with that when injecting past brews.

Use a 22.5nm filter if you want sterile gear. If an abscess is what you are looking for use a 45.

 

[T_verde77]

I've never got an abses filtering with .45 but there's no reason to take that risk

 

[Notits]

There is zero good reason to skimp on filtering. If you are willing to gamble on sterility you are a complete moron.
Use a .22 and stop rushing things.