Is my needle to big

[Ghoul]

Spike don't last much at least the one I got the filter get melted by the BA and BB after maximum 6 draws on average. Filtered needle is where I'm going next. A lot easier and quicker to multidose too.

Must he recipe dependent. I get 20 x .5ml draws no problem. Even broke it open and found filter perfectly intact

I was referencing an unfiltered spike above anyway. .

 

[Sampei]

So, you think the advice about spikes should be revised, in favour of your approach, or not?
Is it just about durability + cost

Depends I guess. Maybe my spike are less resistant and the Braun one are better.

Cost is more or less the same, maybe spike cost even less depends how much they last.

Let's assume one spike cost you 3$
One filtered needle is 0.50c so 6 needles cost the same as 1 spike.

After 6 draws the spike has one and it's costing less.

Thing is if you need to draw different substances in the same syringe the spike is a pain in the ass, the needle win 10 to 1.

Both are fantastic options and one or the other should be used.

Aesthetically spike are horrible.

 

[Sampei]

Must he recipe dependent. I get 20 x .5ml draws no problem. Even broke it open and found filter perfectly intact

I was referencing an unfiltered spike above anyway. .

Yeah I believe so, I'm using it for primo 25% BB and after a while it stops drawing. Like you pull and nothing comes out.

With bac water it never stops working.

 

[egruberman]

27g 1/2" is what god intended for delts.

You must have tiny delts. I can sink a 1-1/2" 27g in my delts just fine.

Also, BD only.

Everything else is a rusty serrated knife by comparison.

Nipro is pretty good as well.

30G with a 1ml syringe

Pushing 1ml of oil through a 30g needle takes forever. Maybe if you're on a baby cycle. I like 27g for oils.

 

[RekTest]

You must have tiny delts. I can sink a 1-1/2" 27g in my delts just fine.



Nipro is pretty good as well.




Pushing 1ml of oil through a 30g needle takes forever. Maybe if you're on a baby cycle. I like 27g for oils.

Literally takes less then 15-10 seconds, I pin 3ML daily.

 

[Sampei]

Literally takes less then 15-10 seconds, I pin 3ML daily.

I doubt it very much as it takes that fine and some more with a 27G. 30g brings a lot of velocity to the oil exiting the needle and that's not the best either.

Make a video of you injecting wjth a 30g in 10/15 seconds. I don't believe it.

I call bullshit, MCT it's doable but a pita GSO is not even probably possible without breaking your fingers.

3ml daily? You 290 lbs?

 

[Sampei]

You must have tiny delts. I can sink a 1-1/2" 27g in my delts just fine.



Nipro is pretty good as well.




Pushing 1ml of oil through a 30g needle takes forever. Maybe if you're on a baby cycle. I like 27g for oils.

Same 27G is a great size. I was looking into 30g but I decided to stay with 27g.

Nipro great brand too.

Fucking hate Terumo instead.

 

[laclark89]

Why not just core and inject a small piece of rubber into your body lol.

25 ga 1 inch is good for anything enless it ur fat af.

Can anyone actually draw even mct with a 30ga ? Even mct without back loading?

 

[laclark89]

Why not just core and inject a small piece of rubber into your body lol.
[/QUOTE

That’s only a 10ml vial and I’m only half way through. Kinda scary lol.

 

[RekTest]

25 ga 1 inch is good for anything enless it ur fat af.

Can anyone actually draw even mct with a 30ga ? Even mct without back loading?

Youll never draw oil with a 30g, luar lok it

 

[egruberman]

Make a video of you injecting wjth a 30g in 10/15 seconds. I don't believe it.

This. Takes me at least that long with a 27g for MCT.

Can anyone actually draw even mct with a 30ga

Yeah. If I want to throw in a little tren, that ends up being .2 or .3ml per day. Anything more than that and I wouldn't. I draw it up with a 30g 1/2" and have no problems getting it IM.

 

[Grey Spartan]

25 ga 1 inch is good for anything enless it ur fat af.

You would have to be obese for a 25g/1" not to work

Can anyone actually draw even mct with a 30ga ? Even mct without back loading?

I tried a 31g one time and it did not work lol. I use a 29g and back load but it can be injected in 10-20 seconds.

 

[Sampei]

25 ga 1 inch is good for anything enless it ur fat af.

Can anyone actually draw even mct with a 30ga ? Even mct without back loading?

No or yeah you can but it takes like ages and the oil need to be super warm..anything that isn't MCT can't be drawn with a 30G.

I have difficulties drawing with a 27G, I use a 25G to draw usually

 

[Ghoul]

You must have tiny delts. I can sink a 1-1/2" 27g in my delts just fine.

Not sure what size of delts has to do with it. If someone's fat as fuck they might need 1.5" to reach them, otherwise, why do I want to go deeper than necessary?

Besides, deeper means faster absorption (more scar tissue as well), and for TRT I'm not looking to maximize the rate of T level rise.

I do prefer 27g, mainly because they're more sturdy, and require less pressure to push the oil in.

 

[egruberman]

Not sure what size of delts has to do with it. If someone's fat as fuck they might need 1.5" to reach them, otherwise, why do I want to go deeper than necessary?

When you have bigass delts like me, it doesn't matter than the only 27g Nipro needles you can find are 1-1/4", which is what I'm presently using (not 1-1/2" as I wrote, I just checked my order).

I'm teasing really. When I can find 1", that's what I'll use.

 

[Type-IIx]

Coring is bad if you draw with 20g

Never been an issue tbh. I only pin twice a week at most from any multi-use vial, and they're only 10 mL. Everyone has their preference, this works great for me.

 

[Type-IIx]

I guess I did have an issue using trenbolone acetate with the 20 gauge though, with coring, now that I think of it. I know what you mean. I just don't use it anymore, so I've forgotten. It's just enanthate for me now. Fewer pins is my preference always.

 

[laclark89]

I guess I did have an issue using trenbolone acetate with the 20 gauge though, with coring, now that I think of it. I know what you mean. I just don't use it anymore, so I've forgotten. It's just enanthate for me now. Fewer pins is my preference always.

I agree even though i don’t like tren e.

The less times you pierce the derma the less chance for infection or bad shot.

The that’s y I like test decca, 1x a week.
I give 2 craps about steady levels. What did they do in the golden era.

 

[MickieGord]

1/2" 29g works fine in delts for me