Making 200mg/mL mix of Cyp and Prop

[Blue09]

Hey folks, when making a 100mL solution of test cyp/prop mixx @ 200mg/mL, would 1.5%BA and 20% BB be enough to hold it in solution or would it crash? If it would crash, how much should I add?

 

[Nytol]

Hey folks, when making a 100mL solution of test cyp/prop mixx @ 200mg/mL, would 1.5%BA and 20% BB be enough to hold it in solution or would it crash? If it would crash, how much should I add?

How much of each ester do you want in the final product?

If you want 50mg Prop/150mg Cyp, your ratios will probably be fine.

If you want a 50/50 split then I would up the BA to 3%.

 

[Blue09]

Yea, I wanted a 50/50 split. That would be fine as far as holding in solution?

 

[Nytol]

I would think that 3% BA and 20% BB should hold nicely.

 

[MaxRep]

I've made Test prop at 100mg/ml and 5%BA with 15%BB worked well.

MaxRep

 

[Blue09]

Bringing this back from the dead....lol. At 100mg/ml along with another Test. (Cyp or Enan)....will this be a painful injection? Most people I hear say they normally feel pain at 150mg/mL but some don't. I have heard of PVL making a 300mg/mL Prop that is completely painless! Anyways, if everything is sterile, should I really have any problems with pain? Im not concerned about slight pain the day or two afterwards....it's just the horror stories of being in such bad pain that it's hard to sit down comfortably....