Mast-P PIP

y777

Member
Hi guys

Just wanna get some feedback on Mast and PIP. Running >500 mg Mast-P, about a month into it. Finished oil from QSC.

I have no PIP issues when injecting VG but delts or any other body part and i am so bloody sore after. Next day especially. I use a massage gun on the site right after. I don’t experience this with Primo 200mg, Test-P. I would venture to say that the pip is worse than winstrol oil (50mg strength )

Is this normal or it could just be the brew ? How’s Mast-E ? Is it better ? Thinking for my next cycle I’ll do what I’ve seen sone guys post and that’s run the enan ester co currently with prop and then take the prop off after two weeks , but that’s for another thread

Any site at half an inch = PIP. Even 1.5 inch needle full depth into delts I get PIP. Like worst shoulder workout PIP.

It could be dose dependent but I get it with even 0.30 cc , 1.5 inches into delt.
 
Most of my pins are to VG. I’ve tried shorter needles and even 1 inch ones leave soreness. Got used to 1.5 when I ran winny before : 0.5 inch pin into quads and I can’t walk the next day, 1 inch and I’m sore , but 1.5 inch into VG and I’m good to go even up to 100 mg winstrol oil

// edit. This is 1.5-2 ml of oil that I inject.
 
I’ve run Qsc mast p and test p and got nothing like you’re describing. But I use 1 27ga for VG and G sites and 1/2 27 for delt. I notice a tiny bit of soreness when I do delts the next day and 0 in VG or G sites. I don’t warm it or massage gun either but do go very slow pushing the oil in. Sorry if I can’t be more helpful but I heard oil warm up in a coffee mug helps combined with a very slow oil injection of at least 1min followed by the massage gun.
 
First: pinning that deep in the delts is passing the delts and likely ending up in the rotator cuff tendon. Second, Mast P is a short ester but you mentioned mast E… double check that it is E and not P. Third: if it causes you PIP, why are you still pinning it? If there is any issues with PIP, you don’t pin it again. Possibility of accumulation or maybe crashing in your body part. Srop pinning it until you feel no pain and use 1” pins.
 
Brother. You only need 1/2” muscle penetration to retain oil. Unless someone is very obese… 1.5” is extreme. I only use 1” on glutes. (I consider that overkill) Go slow on injection, don’t use a gun. Just a heat pad. Gun will create more problems than solutions. Long needles run a higher risk of tendon and connective tissue damage. Risk/Reward is lopsided
 
Back
Top