Mct oil vs EO

Roco Bama

Well-known Member
Which carrier is a lot thinner ? Mct oil from my experience is slightly thinner than gso. Is EO also the same ?
 
Of the two EO is the thinnest. If you have not used it I recommend you only brewing a few mL and injecting 1/2mL. From my experience, thinnest being:

1. EO - severe allergic reaction
2. Myg 840 - knotted up, PIP 4-5 days
3. MCT - zero issues, just warm it up pre-injection, runs smooth.
 
Of the two EO is the thinnest. If you have not used it I recommend you only brewing a few mL and injecting 1/2mL. From my experience, thinnest being:

1. EO - severe allergic reaction
2. Myg 840 - knotted up, PIP 4-5 days
3. MCT - zero issues, just warm it up pre-injection, runs smooth.
you got bad allergic reaction from EO ?
 
you got bad allergic reaction from EO ?

Unfortunately I did @Roco Bama, reason I told you to try a small quantity-1/2mL just in-case you also get an allergic reaction though not everyone does. If you are one that doesn't respond negatively to it then those injections are a breeze, 400mg/Test Ent flowed through a 27gx1 smoothly.

My allergic reaction started with a slight tightness of chest, nothing severe, then my inner thighs started itching excessively followed by my arms & underarms.(just imagine goosebumps and a few rashes) It was a bit scary, good thing I had some Betamethasone and antihistamines on hand.
 
Of the two EO is the thinnest. If you have not used it I recommend you only brewing a few mL and injecting 1/2mL. From my experience, thinnest being:

1. EO - severe allergic reaction
2. Myg 840 - knotted up, PIP 4-5 days
3. MCT - zero issues, just warm it up pre-injection, runs smooth.
Why even brew a small amount? Can’t he just pin some straight EO to see any reactions? A wasted pin, but no wasted gear.
 
Why even brew a small amount? Can’t he just pin some straight EO to see any reactions? A wasted pin, but no wasted gear.

Good point, though you never know the quality or impurities of your raw powders. Reason I suggested brewing a small amount. Say 10mL x 200mg = 2g of raw powder. I've had some Test E give me some horrible PIP and another one, 0. Different batch.
 
Back
Top