microwaving gear

[Whid]

if a bottle of test is crystalized due to low BA, will it be harmfull for the product if it is re-microwaved before each injection???

 

[gman67]

I would just heat it and redissolve it and add a little more ba. If you don't have ba then you'll just have to reheat everytime. Don't know if I'd throw it in the microwave though. I just put a kettle or pot on the burner, stick the bottle in it and heat slowly until dissolved.

 

[chris gordon]

how you gonna do that? doesnt the vial have a metal top? put that in the microwave and sparks will fly....just put it in a pot with an inch of water and set on medium heat for a few minutes

 

[4545]

boil some water....let it sit for like 5 mins then just swirl the juice around in the water but make sure you dont get any on the top of the vial where you draw from just to be safe. After i load my pinz with juice i take the pin off and heat it in the microwave for 10 secs it really helps go's in alot faster and cuts down on stinging and irriation.

 

[cinnabar8521]

Microwave's don't heat evenly, you may end up frying parts of the bottle and barely heating other parts.

 

[J DUB]

I think he is in college, if so then I doubt he has a burner in his dorm room. A better option would be if you have a sink in your room (or use the hall one late at night), get the water as hot as possible and just hold it under the water for a few minutes, shake it up well and repeat if necessary. This works well for me if I have that problem.

 

[Whid]

lol... nah it works fine in the microwave.. no sparkin at all.. i was just wonderin if it ruins it by re-microwaving it over nad over

 

[Whid]

plus i was only heatin it for like 20 seconds then shakin it... it would completley disolve..

 

[chris gordon]

whid i got some BA if you need some