Mixing EQ and Test

[Data1000]

When mixing EQ and Test in the same needle, is it easier to first load the Test or the EQ? I've never mixed before and want to be careful not to accidently inject some EQ into the Test bottle (or vise versa) when I am pushing out the bubbles.

Thanks.

Remember there are no stupid questions, just stupid people.

 

[sleezedog]

Don't matter, just be careful and watch the bubbles.

 

[4545]

Do the test first so that way you wont feel the sting b/c the Eq will be the 2nd to be loaded and at the tip of the syringe/needle.

 

[ipfan1]

if ur test is in an amp, do the eq first so you can measure better.

 

[eleven11]

I alway draw the test first then the Eq the eq seems to be a little thinner and it mixes right into the test..........no pain.

 

[Data1000]

Do the test first so that way you wont feel the sting b/c the Eq will be the 2nd to be loaded and at the tip of the syringe/needle.

That makes sense. Is there any problem with accidently shooting a little bit of Test into the EQ bottle when removing bubbles?

 

[eleven11]

That makes sense. Is there any problem with accidently shooting a little bit of Test into the EQ bottle when removing bubbles?

I wouldn't worry about that... Besides the worst that could happen is you have a nice test/eq cocktail at the end of your bottle..

No really unless your pumping a 1/2 cc back in there dont worry about it. just watch your gear as it starts into the needle and stop....11

 

[txstud]

dont have the needle in the vial when removing the bubbles.

 

[KTCKSports]

When is your cycle starting? I will be doing the same cycle in a few months.

K-

dont have the needle in the vial when removing the bubbles.

 

[shredalean]

Doesn't matter the trick is to hold the plunger back when you go into the new vial, other wise if you don't have your hand on the plunger a vaccum can be created and you'll watch your test go right into the other bottle. No need to worry about bubbles, flick the needle before you inject they disapate then you shoot and grow!

 

[ren]

im on test/eq cycle right now ...ive always done the test first just so that if i get distracted after i take the pin out of the bottle and place it down fora minute, i know where im at and i dont have to guess....whatever you pull first..just keep it consistent so that one time when you cant remember which you just pulled and youre staring at the two bottles , youll know

ren

PS ..i HAD a point in there somewhere

ren

 

[atlas]

mixiong

i mix my prop and EQ in the same syringe all the time with no problems.

 

[demeurj]

When mixing EQ and Test in the same needle, is it easier to first load the Test or the EQ? I've never mixed before and want to be careful not to accidently inject some EQ into the Test bottle (or vise versa) when I am pushing out the bubbles.

Thanks.

Remember there are no stupid questions, just stupid people.

Load the Test first since most preparations (even Sustanon) will have a lower half-life than the EQ. I'm a newbie currently running Sus and EQ. I actually had a different rxn than most. My first injection was EQ only which had a little sting but EQ/Sus has been easy on the glutes.

Despite being viscous it is actually quite easy to remove bubbles from oils but once you are in the EQ (after the Test) your remaining bubbles will require removing the pin from the EQ. Just roll the syringe to move bubbles towards the neck of the pin . . . then all it takes is a couple of drops to expel the remaining air.