MESO-Rx
Anabolic Steroids
More Experienced ppl. pls
- Thread starter Evo N800
- Start date
Is it important that I aspirate the pin when I shoot as well?
This is my first cycle and have little experience but have read everything I could find. I want to make sure that I don't get anymore uncomfortable that it already is.
What am I looking for when I aspirate the needle once I have penetrated my thigh and Why is the vacuum suction so hard when I'm trying to get my gear out of the jug. It like took me two tries to get 1.5 cc in the shringe. Is there a sit for reading up on proper procedure.
This is my first cycle and have little experience but have read everything I could find. I want to make sure that I don't get anymore uncomfortable that it already is.
What am I looking for when I aspirate the needle once I have penetrated my thigh and Why is the vacuum suction so hard when I'm trying to get my gear out of the jug. It like took me two tries to get 1.5 cc in the shringe. Is there a sit for reading up on proper procedure.
Chip Bronson
New Member
Evo N800 said:
i use 25g 1" or 1 1/2" for quads. 5/8" will just not get you deep enough into the muscle, unless you have, like, no bodyfat.
definitely aspirate, especially in the quads as there are lots of blood vessels there. when you pull back the plunger, about an 1/8" is good, you should not see any blood. you'll see some kind of bubbles, maybe even some white-ish 'stuff'. not problem there. if, however, you see blood in the syringe, pull needle out, change needles and hit another spot.
before pulling gear out of the jug, inject air into the jug in an amount equal to the amount of gear that you'll be using. e.g. if you're going to be pulling out 2 cc's of gear, then inject 2 cc's of air into the jug. this way you're not working against the vacum in the jug. not to worry about this but be careful.
Southernjuice
New Member
And...always use an alcohol pad to clean the top of your vials before sticking your needle in it and of course do the same to the area on your body you're going to inject...be safe bro
Chip Bronson
New Member
Evo N800 said:
i think i speak for all of us when i say, you're welcome. that's what we're here for bro. glad to help.
Grizzly
New Member
5/8" is too short. 1" is much better. You want to get the juice deep into the muscle. Definitely aspirate, too. Never, never, never don't aspirate or you'll be learning from your own mistakes that it's a bad idea.
As far as the soreness goes, that's typical. Most gear hurts. That's just part of the game.
As far as the soreness goes, that's typical. Most gear hurts. That's just part of the game.
I will go pick up some 1" pins tonight. (23g)
Does it also help to warm the juice up a bit. I don't mean like Microwave or anything but running it under warm water? I really want to get it right so that I never, Never, pass on bad information to someone who might be in my place one day!
Thank bros, and yes I do wipe the top of the jug and inj. spot with alcohol wipes.
Does it also help to warm the juice up a bit. I don't mean like Microwave or anything but running it under warm water? I really want to get it right so that I never, Never, pass on bad information to someone who might be in my place one day!
Thank bros, and yes I do wipe the top of the jug and inj. spot with alcohol wipes.
joe shmoe
New Member
i find that shooting quads is the most painful/uncomfortable. glutes and delts i handle alot better.
as far as fighting the vacuum, to add to chips response about shooting air into the vial, i usually draw a full syringe worth of air and shoot that into the vial. even if i'm only drawing 1cc. a little positive pressure inside the vial makes it easier to draw.
i usually let hot water run on my syringe before i shoot. hot tap water. no need for boiling. the heat makes it easier for the oil to flow. especially when using 25g needles....like chip and most women do
(sorry chip...i'm feeling frisky).
have a nice day
as far as fighting the vacuum, to add to chips response about shooting air into the vial, i usually draw a full syringe worth of air and shoot that into the vial. even if i'm only drawing 1cc. a little positive pressure inside the vial makes it easier to draw.
i usually let hot water run on my syringe before i shoot. hot tap water. no need for boiling. the heat makes it easier for the oil to flow. especially when using 25g needles....like chip and most women do
(sorry chip...i'm feeling frisky).have a nice day
I think he meant shooting in the quads fucked up his nerves. It's happened to me...it's a really awful (not painful, just "icky") feeling. Like fingernails on a blackboard. I frickin' hate injections. I'd even use a suppository if they made it that way.txjustin said:
Last edited:
