Multidose Vial Adapter

[verylargeshoes]

I would not put them anywhere near oil with BB. There is pic here of that particular model cracking while in service.

I had one in a vial of test prop 100 in MCT oil that after a couple of weeks could no longer hold negative pressure so I couldn’t fill through it. I probably only actually pulled through it 3-4 times. I have no reason to believe that was an especially caustic brew.

 

[TurboJet]

So this is like trying to use a condom to be safe but you got it of the tack board and kept it in your wallet for a few years....

It made her feel better about it so that still counts

 

[TurboJet]

So this is like trying to use a condom to be safe but you got it of the tack board and kept it in your wallet for a few years....

It made her feel better about it so that still counts

 

[TurboJet]

 

[archive]

I had ordered some of these before I saw the reports of them failing. Decided to go ahead and try it.

So far, no failures. Use them for about a month at a time. Perhaps I have lower solvent oil.

I'll probably look for alternatives once these run out, I probably get enough microplastics elsewhere.

I also ordered some of these Braun adapters a while ago except I got the model with the red tips and smaller vent filters.

I've used two so far with daily pins. The first lasted about 3 months before the luer lock srcrew on receptacle started to crack off. That easily could have been ape-handed user error from over tightening the syringe. That was pulling GA TC250 for what it matters.

The second is still going strong at about 3 months of daily pins. I've been trying to be careful with how I connect the syringe on this one. This one's pulling a different oil. It's a domestic TPP 150.

I plan on using these unless I notice corrosion on the inside of these adapters

 

[Ateam2023]

these have given me no problems, Meds lab supply

 

[hexagonal]

I had ordered some of these before I saw the reports of them failing. Decided to go ahead and try it.

So far, no failures. Use them for about a month at a time. Perhaps I have lower solvent oil.

I'll probably look for alternatives once these run out, I probably get enough microplastics elsewhere.

I did end up having issues that I strongly suspect were caused by BB leeching the polycarb into the oil. Likely started just a week or so after this post, even. Jinxed myself, I suppose!

H

Post in thread '(US) Vendor gear found with dissolved brewing equipment (Plastic)'

Oct 8, 2025

How toxic is this?
I have no idea, however I have zero plans to inject from any vendor that has any products containing dissolved plastic.

I keep meaning to post this in one of the threads where those inline filter multidose adapters got suggested but keep forgetting, since last I posted about them they had been fine and that I planned to use up the ones I had purchased. But since this directly reminded me:

I'm fairly certain the BB dissolving the polycarb in them resulted in sterile abscesses at the injection sites. It ended up impacting me in 4 places. I didn't notice the...

• hexagonal

• 

 

[Bammdk]

So backloading slin pins is off? Or 1-3 days ok? Or use a sertan type?