My proof of concept for vaccume filtering

[ThinkTrenbolone]

this allows you to take one 60ml syringe. One 100ml vial. One ptfe 0.22micron filter 30mm and filter through vaccume.

This allows you to utilize the standard syringe filter setup however it automates it and helps you stop having to crank down on a caulking gun. Use hairdryer to heat up the syringe randomly when the oil cools down. However this is simply just a general vacume filteration system with out needing to buy one and still keeps the system sterlized as long as you replace the syringe. Needles and filter.

Once finished. You can then transfer your oil to small 10ml vials as you please. Still keeping the entire system sterlized.

 

[ThinkTrenbolone]

@Spaceman Spiff

 

[narta]

That's excessive. Use a proper bottletop with glass gl45 receiver or a inline filter with a peristaltic pump.

I personally don't see the need for anything more than the standard caulking gun/syringe filter/pre sterilized vial for personal use.

 

[Spaceman Spiff]

@Spaceman Spiff

For personal use? This is a bit much.

No offense, but I can't help you for anything past the caulking gun method

 

[bighunanballs]

without top pressure on the syringe with vacuum assist you will prob be slower than a caulking gun (even if you can seal the 60ml syringe and add a few lbs of pressure in the headspace itll still be slow). if you use an elec vac pump instead of the hand pump you can at least walk away and leave it for the day then come back later.

do a test run with mct and see how it does.

youll prob find out this has been tried a million times by bros in the past to speed this shit up and it always ends in caulking gun or go to bottle top filter

 

[ThinkTrenbolone]

without top pressure on the syringe with vacuum assist you will prob be slower than a caulking gun (even if you can seal the 60ml syringe and add a few lbs of pressure in the headspace itll still be slow). if you use an elec vac pump instead of the hand pump you can at least walk away and leave it for the day then come back later.

do a test run with mct and see how it does.

youll prob find out this has been tried a million times by bros in the past to speed this shit up and it always ends in caulking gun or go to bottle top filter

Was considering adding an electric caulk gun in the mix or a electric pump. We shall see.

 

[ThinkTrenbolone]

without top pressure on the syringe with vacuum assist you will prob be slower than a caulking gun (even if you can seal the 60ml syringe and add a few lbs of pressure in the headspace itll still be slow). if you use an elec vac pump instead of the hand pump you can at least walk away and leave it for the day then come back later.

do a test run with mct and see how it does.

youll prob find out this has been tried a million times by bros in the past to speed this shit up and it always ends in caulking gun or go to bottle top filter

I do believe heating the oil help this alot. As for the slowness the main purpose was to automate it and not have to baby it.